1, after the skinning pheasant is killed and bled through the mouth, plug the mouth and anus with cotton to avoid blood, saliva and feces polluting the feathers. First, separate the trunk: cut the skin in the middle of the pheasant sternum, and be careful not to damage the crop; Peel off the skin and crop, pull out the trachea and esophagus from the neck, then cut off the trachea and esophagus behind the crop and take it out of the body; Cut off the cervical vertebra and gently pull out the cervical vertebra; The skin of the trunk is separated from the shoulder joint, and the shoulder joint is cut off, so that the wings are separated from the trunk; Then peel back the knee joint and cut it off, leaving no muscle in the tibia; When splitting the tail, don't peel off the tail feather; Cut off the coccyx and rectum, cut off the fat gland of the tail, completely separate the skin from the trunk, and take out the trunk; Then, peel off the skin on the wings and gently push the skin at the ulna down to the wrist, so that the ulna can support the muscles.
2. Treat skin and skeletal skin ectropion, remove the fat and connective tissue remaining on the skin, and then apply camphor and talcum powder. For the residual bone, it can be treated with 10% formaldehyde: after the tiny bone has its periosteum scraped off, it is coated with cotton to absorb formaldehyde several times; Thick bones need to be drilled and formaldehyde injected into them.
3. Manufacture of support trunk and neck support: bend the iron wire into an ellipse slightly smaller than the pheasant carcass, and interweave the two iron wires at the front end into a twist shape with the same length as the neck. , from the neck into the head, the end bifurcation stuck in the cranial cavity, with cotton plug. Fabrication of hind limb support: Insert two iron wires upward from the toe bottom incision, leaving 5 cm at the end, and connect and fix the top with the body support. There must be more than five fixing points, and the length of iron wire should be adapted to the length of hind limbs, and the residual bone should be fixed with iron wire. Fabrication of the biplane bracket: Use a steel wire with two ends extending from the shoulder to both ends of the biplane, leaving about 3 cm of skin on each side, firmly connecting the steel wire with the trunk bracket into a whole, and fixing the remaining bones with steel wire. Manufacture of tail feather bracket: a metal wire is wound and fixed on the back of trunk bracket, with both ends bifurcated upward and inserted into both sides of coccyx for fixation.
4. Filling suture Put the prepared skeleton into the peeled goose skin, and fix one end of the iron wire in the body axis direction on the skull and the other end on the coccyx. Then use mildew-free, dry and clean cotton, shavings, old threads and other materials to fill the pheasant's body (sprinkle some insect-killing and mildew-proof drugs such as camphor powder and borneol before filling), sew with threads, and finally arrange the chest feathers to cover the suture site and install artificial eyes.
5. First, shape and color, adjust the joint angle of hind limbs to make the pheasant specimen stand or run normally, then adjust the posture of its wings and open them to both sides, or naturally fold its wings when standing, cut off the iron wire with one end sticking out of the skin, then adjust the posture of its head and neck, and finally wrap the specimen tightly with gauze and dry it in a cool place in a ventilated and dry place. After the specimen is dried in the shade, it needs to be colored, that is, the crown, wattle, earlobe, shin and toe are coated with oil painting pigment, and its color must be consistent with the appearance color of the pheasant variety. After the pigment is dried, it is coated with a layer of oil or varnish to make the feathers more colorful.