Veneer production process: cut common cheap logs into certain lengths and soften them. After the wood section is fully softened, it is sawed out of the pool and sawed out according to the requirements of straight line or gable line. Then, according to different thickness requirements, the wood square is cut into thin wood with a planer, piled up manually, and then the burr of the thin wood is cut off with a cutting machine to form thin wood with different widths. Next, put the veneer into a stripping pool with a special tool holder for stripping. Until the original wood color completely faded. Then, the liquid medicine on the veneer is fully filtered with clear water and put into a dyeing vat for heating and dyeing. At this time, the most important thing is to master the ratio and temperature of pigments. Generally, according to the target color matching, the color number ratio and mass ratio of each clock are analyzed by computer, and then the materials are accurately weighed in proportion. The dyed veneer 1 needs to be dried 70% before it can be used for veneering. While veneer 1 is being produced, the base material 2 for veneer is also being prepared. The defects on the surface of the substrate 2 that affect the flatness of the finished product should be treated first, then polished, and then the corresponding color masking agent should be selected according to the different colors of the veneer for coloring and drying. The surface color of the integrated substrate 2 is the same as or close to that of the veneer 1 and kept dry. After the base plate 2 and the veneer 1 are ready, prepare the glue 3. Add a proper proportion of flour and veneer with similar color into glue 3, and then fully stir it with a blender for later use. After veneer 1, substrate 2 and glue 3 are prepared, glue the substrate 2 with a glue coater. Then, the veneer 1 is attached to the substrate 2 in turn manually to form a veneer blank. After the veneer blanks need to be collected and piled manually, they are sent to a cold press for cold pressing, so as to speed up the initial bonding of veneer 1 with substrate 2. Generally, it can be sent out after 1-2 hours, and the veneer wool head can be cut off. In order to deal with the man-made overlapping seam in veneer veneer veneer, it is necessary to manually check and further repair the flat seam defects in veneer and sanding, and then send the blank to the hot pressing process, and press and dry the blank with a hot press, so that the glue 3 can be thermally cured to reach the standard bonding strength. At this time, the blank board has completely become a single board. In order to check the quality defects produced in the hot pressing process, it is necessary to carry out manual renovation before grinding, and finally grind to get the finished product.