The structural diagram of Honda Jade bumper is as follows: The following is the disassembly method of Honda Jade bumper: 1. First of all, you need to prepare the tools needed for the whole process of the rear bumper, including screwdriver, small wheel, t-25 sleeve, t- 15 spline and t-25 spline, and then you can start disassembly. 2. Disassembly of rear outer taillight. Open the trunk lid. Here we disassemble the left rear outer taillight first, as shown in the figure. Break off the cotton wool on the left lining of the suitcase by hand. At this time, you can find plastic screws who fixed the left rear outer taillight. Hold the button and turn it counterclockwise by hand to remove the plastic screws. The removed screws should be put away for installation. 3. Unplug the harness plug of the left rear exterior taillight, so that we can take off the left rear exterior taillight. Hold the light surface of the left rear exterior taillight and pull it back, so that the left rear exterior taillight is separated from the car body, and the removed rear taillight should be put away. 4. Next, remove the right rear outer taillight. The removal process on the right side is the same as that on the left side. We need to pay attention to that, put away the removed plastic screws and taillights for installation. 5. Remove the fixing screws of the left and left rear fender bushings of the rear bumper. Take out the small wheel, fit a t-25 sleeve, and then disassemble the screws that fix the left side of the rear bumper one by one, three screws. Take the removed screws away, take out the t-25 spline, remove the screws on it with the t-25 spline, and put the removed screws together. 6. Remove the screw on the right side of the rear bumper. Similarly, take out the small wheel, fit a t-25 sleeve, and then remove the screws that fix the right bumper one by one. One * * * has four screws, so put away the removed screws. 7. Remove the screws that fix the rear bumper. Take out the t- 15 spline, and remove the plastic screw under the rear bumper with the t- 15 spline. A * * *, a total of 6 pieces, please disassemble them one by one, and pay attention to put away the removed screws for installation. 8. Now, all the screws fixing the rear bumper have been removed. Hold the edge of the rear bumper by hand, and then break it off with a little force, so that the rear bumper can be separated from the strip guide groove on the car body, and both the left and right sides need to be broken off. 9. So the rear bumper can be removed, and the whole disassembly process is over.