Current location - Plastic Surgery and Aesthetics Network - Clothing company - Steps in ocean centre
Steps in ocean centre
Heart of the Sea Ribbon DIY Heart of the Sea manual steps are as follows:

Preparation materials: ribbon 4x 18cm2, double-sided tape, lighter, scissors, ruler, etc.

1. Cut two 4x 18cm ribbons, fold them in half to make creases, and stick them with double-sided tape.

2. Tear off the double-sided adhesive tape. After the two ribbons are overlapped and fixed, the right side is folded into a trapezoid along the midline.

3, the left side length is also the same folding method.

4. Fold the two parallel sides of the trapezoid in half, and both sides must be folded in the same way. Be sure to hold it with your hands, otherwise it will easily spread out.

5. Fold the ribbon in half.

6. Cut it with scissors at an angle of about 45 about 2 cm away from the ribbon.

7. Burn the incision position with a lighter, and then clamp it with a clip to make the opening stick together.

8. After loosening the ribbon, flatten the scalded area inward.

9. Fold the formed sharp corner inward and fix it with hot melt adhesive, or burn the ribbon with a lighter, and then quickly press it on the bottom of the ribbon to fix it. Hot melt adhesive is recommended.

10, after fixing the back, turn the ribbon over and put it on the front, and you can already see the overall outline of the heart. We will tighten the bottom corner of the ribbon inward to make the heart more perfect. Burn it a little with a lighter, and then hold it in your hand.

1 1. When the heart at the bottom of the ribbon is perfect enough, let go of your finger, and this one in ocean centre is ready.

Matters needing attention in making Heart of the Sea with ribbon DIY

1, determine the pattern: you can make it according to the standard pattern in In the Center of the Sea, or you can design personalized patterns according to your own ideas.

2. Measuring proportion: After determining the pattern, measure the length-width ratio of the ribbon and place the pattern symmetrically.

3. Fixing the pattern: After determining the position of the pattern through measurement, glue the ribbons together to fix the whole pattern.

4. Carving pattern: Use a carving knife to gently draw the outline of the pattern on the ribbon to help draw an inverted triangle.

5. Draw an inverted triangle: Draw an inverted triangle according to the requirements of the pattern of the heart of the sea. Need to pay attention to the angle and position.

6. Fill color: Fill the gap of the inverted triangle with the matching ribbon color to enhance the layering of the color block.

7. Fix the ribbon: After painting, glue and fix the ribbon with a rubber brush to avoid loosening and deformation.

8. Edge treatment: the edge of the ribbon is treated and decorated to make the overall effect complete and complete.