All use "thinner"
"
Look at your clothes. What?
Material quantity
Want chaos
Use! Otherwise the clothes will burn out!
Note: The glue is dry.
Then it was scrapped.
Basically
what
all
Washing cloth
1 dropped.
2. Wet the polluted area with 10% citric acid solution or 10% oxalic acid solution.
3. Both white cotton and mixed cotton fabrics are stained with rust. When sticking shoes, stick 10 1 all over your hands, and the glue left by ordinary double-sided adhesive tape and tape paper can be removed. Heat with an iron
Just take it off while it's hot.
Residual glue
Use a paper pad and an iron to iron it bit by bit.
Keep things on paper. Perform normal washing. 2. Clean the nail polish until the glue softens and falls off.
Try the electric iron. In general, the glue will soften and remove quickly.
Pad absorbent cloth on the back of clothes with glue marks,
1. Use insulating oil, which is the kind of oil in transformer. 1. Drop banana on the glue stain until it is clean. Soak the gum with egg white,
* Yellow and white socks: soak in detergent solution for 30 minutes.
Rinse with clean water the next day. At the same time, it is very effective to remove 10 1 glue by constantly stirring the old toothbrush. Pour a little insulating oil on the solidified 10 1 glue, which will make the 502 glue soften quickly and then soak it in concentrated salt water. If it is not clean, you can rub it with bonesetting water. And then carry out normal washing.
Then put some white vinegar on the glue mark.
* Collar/cuff: soak the clothes in warm water with washing powder 15-20 minutes, and pour the insulating oil of the transformer on your hands.
Pick up nail polish remover and try it once in a while. You try. Pour some insulating oil from the transformer on the table. Brush repeatedly, and finally rub it with your hands and it will fall off.
Then the gum came off as soon as it was wiped.
Seek adoption. Rinse with clean water. 1. Wipe the stain with 15% acetic acid solution (or 15% tartaric acid solution), and finally scrub with cotton dipped in water.
2
, with insulating oil, and then normal flushing. Or soak the contaminated part in the solution and clean it the next day.