Materials: adhesive tape, flower core, iron wire, screen, thread, flower pole scissors, mold, pliers.

1. When making a petal circle, the bottom should be tied tightly, otherwise the petals will be of different sizes. See the figure below. Moreover, the thread ring should be formed at one time, otherwise the petals will be deformed.

2. Leave a length of 1.5cm at the bottom of the wire loop to ensure that the socket length is appropriate and looks natural. Moreover, the bottom margin of all wire rings should be the same length, which is also the guarantee of unified binding of sockets. Finally, we should also pay attention to thinking about the image and take shape at one time.

3. Don't set the screen too tightly, otherwise it will easily crack from above and the binding will be too loose. Petals are lifeless, and you can't see the gradient. The margins after binding the bottom net should be consistent. In addition, the margin at the bottom of the screen should not be too small, too little screen is easy to fall off, nor too much, and the socket coming out of Dozza is easy to be too thick.

4. The bottom of all petals should be treated with the same thickness in any way, otherwise the receptacle will be easily deformed after binding.

5. The flower core should be fixed with thread or iron wire to prevent it from falling off. Don't fix the flower core too low, or the flowers will look unnatural. If it is a rose bud, pay attention to the fact that the stem only enters half of the foam bud, otherwise it will pierce the bud when making flowers, which will affect the appearance.

6. The petals should be tied tightly.

7. When tying petals, one layer should be next to the other, and the inner layer and the outer layer of the tying line should be on the same level, otherwise the petals will fall off easily and the receptacle will not be tied well.

8. Finally, tie the petals to the receptacle.