There are many kinds of lamp brands on the market now, and led lamps are the mainstream products in home decoration. So how do you wire the led lights? Next, let's take a look at Bian Xiao.

First, how to connect the led lights

1, double-ended connection: this is one of the common connection methods in the early days. Due to the advantages of convenient wiring, some LED lamp manufacturers have adopted it at present. Short the two pins of the lamp holder, and then connect it to the internal constant current power supply. This connection can only work normally if the traditional upconverter is removed.

2. Single-ended lead-in: One end of the led lamp is not connected, and the two pins at the other end are respectively led into a constant current driving power supply. There is no connection between the two lamp holders, and the biggest advantage is safety. If one end of the led lamp is electrified with alternating current, then the other end is definitely uncharged. When replacing the traditional fluorescent lamp, it is necessary to remove the original upconverter, replace the upconverter fuse and install the lamp tube.

3. Interlaced incoming wires: a new wiring method, but it has requirements for LED lamp driving, including two AC incoming wires. The advantage of this connection mode is that it can work normally with or without an infinite frequency converter. When replacing, just replace the lamp tube, which is convenient to operate.

Second, what should I pay attention to when installing LED lights?

1. When you take it out of the box, you should carefully check the integrity of the product.

2. The distance between the 2.LED lamp and flammable objects should be not less than 0.2m, and a gap of 2cm should be left at the top. In addition, lamps are not allowed to be installed at the zenith or in corners with heat sources. At the same time, more attention should be paid to the separation of low-voltage and high-voltage electrical connections.

3. The wiring of the lamp can pass through the drilling hole, and the wiring behind the lamp can be fixed with wires to ensure its firmness.

4. Ensure that the power cord of the lamp is long enough to be free from tension or tangential force. When the light is dark, don't pull it too hard, let alone tie the wire.

Editor's summary: after reading the above introduction, I believe everyone has a further understanding of how to wire led lights. Please continue to pay attention to our website for more information, and more exciting content will be presented to you later.

Enter the area and get the decoration quotation for free.