Inspection: Check whether the installation area is flat. If the installation area is uneven, please install it in a flat position, check whether the installation tools and accessories are complete, and check whether the power supply is turned off. If not, remember to turn off the power.

Installation of hanger: lead out a part of the power cord, determine the installation position mark of the drying rack, then drill holes at the mark with an electric drill, and then fix the hanger with expansion screws.

Installation of box: put the box of drying rack on the hanger. After placing the box, screw four M5 screws on both ends to fix the box on the hanger.

Installation of bracket group: connect and fix the folding arm with fixing bolts, and then connect and fix the folding arm on the other side into the hole with fixing bolts. After installing the fixing bolt, pass the wire rope through the bolt hole, and then tighten it with the bolt screw. Repeat this installation step on the other side.

Install the hanging rod fittings, assemble the hanging rod fittings and put them into the rings at both ends of the lifting frame, then install the pipe clamp screws, tighten the screws and fix them, then cut off the excess steel wire ropes and put them into the holes of the bracket.

Installation completed: After the installation is completed, connect the power supply to see if all functions can be used normally. If so, the installation is successful. If not, check from the beginning which step is wrong.