1. Prepare the materials to be assembled, unpack the lanterns, and arrange them neatly for easy installation. Unfold the main body of the lantern. That is, the main body of the lantern is pressed round, and the lantern becomes round after hanging the hook inside the lantern. Hang the hook below with the hook above, and then start to install the base of the lantern. Install the upper base. When installing on the base, be careful not to install the font backwards. The installation method is to align the fonts first, and then rotate them in place to complete the installation.
2. Inventory the accessories, arrange the light bars on the small lanterns in turn, then align the light bars with the buckles on the lower plates of the lanterns, and then gently press the light bars into the buckles after alignment. Then install all the light bars in turn, insert the motor inside the small lantern into the position of the upper plate of the lantern, and tighten the screws on it after insertion. Then put the upper plate of the lantern on the lower plate, clamp the other end of the lamp strip into the buckle of the upper plate, and then install the lamp.
3. First, take out all the accessories of the material and arrange them one by one. Take out the lantern, hold the bottom of the lantern with your right hand and press it down on the top with your left hand. The steel wire inside is hung on the hook, so that the lantern can be initially installed, and then the round cover above the lantern is taken out, aimed at the direction of the lantern, and installed. Then there is the round ear under the lantern, which is the same, turning in the same direction. Finally, take out the smallest ear and hang it on the steel wire under the lantern.