Current location - Plastic Surgery and Aesthetics Network - Wedding supplies - Simple balloon modeling course
Simple balloon modeling course
A simple balloon modeling tutorial is as follows:

First, the form of love.

1. Fill the prepared round balloon or heart-shaped balloon with air, and the size should be uniform. After filling, tie the tail inflation port with a fast knot to prevent air leakage.

2. Put the inflated balloon on the table or on the ground and put it in a heart shape. If you can't see it, you can draw a love and pose according to the pattern first. Stick these things one by one with double-sided tape or other sticky objects, and the sticking process must follow the set modeling order to avoid damaging the modeling.

3, after all the glue, a love shape is ready. You can stick it on the wall or put it on the ground. They are all good decorations.

Second, flowers.

1, petal shape usually needs 5-6 balloons with two colors, petals with one color, stamens with another color 2, balloons with the same color and uniform size are glued into a closed circle with double-sided tape, and 4 or 5 balloons are also acceptable.

2. Paste another color on the petals, preferably with each balloon of the petals to prevent it from tilting. If you want to hold it in your hand, you can also tie a ribbon on its tail.

Third, the arch.

1. It takes a lot of balloons to make the arch shape. Prepare the number according to the size of the arch.

2. Divide the filled balloons into four groups and tie them together. It's best to choose two different colors, so it won't look too monotonous.

3. Tie these things on the prepared arched shelf, and the shape will be finished.

Fourth, lollipops.

1. To make a lollipop, you need a long magic balloon. Choose two long balloons of different colors.

2. The two tops are screwed together, about five centimeters in length, and then the five-centimeter part is twisted into an ear shape and connected together.

3. Take a balloon and twist it into an ear shape at 5cm, and put it between the two ear knots in the previous step.

4, along the middle of the ear knot around a circle and then fixed, so two laps, the modeling is completed.