Current location - Plastic Surgery and Aesthetics Network - Wedding supplies - How to twist a long balloon
How to twist a long balloon
There are two ways to twist long balloons: 1. Petal modeling.

To make a balloon shape of petals, you need to prepare a long balloon with an inflated diameter of 2 inches and a length of 60 inches, and then make it as follows.

1. First, inflate the long balloon, leaving a length of about 4cm at the end of the balloon without inflating.

2. Fold the long balloon in half from the middle part, and then tie the balloon and the tail together by knotting.

3. Screw two balloons together near one third of the middle folded part, then screw another third to make it into three sections, and then arrange three rings side by side.

4. After being placed side by side, grasp the twist points of the two parts with your hands.

5. Then use the other hand to press the corresponding point of each ring from bottom to top, so that a ring is pressed in half to make two petals. There are three rings in total, so six petals will be formed.

6. Twist the left and right petals in the picture above to the center store and separate the shape of each petal. After fixing, the petal-shaped balloon is made.

Second, bear modeling.

1. Prepare a long balloon with a tail length of about 10cm, then fill it with air, and screw out bubbles of 8, 6, 2, 6, 2 and 6cm from beginning to end.

2. Screw the ends of the first bubble and the last bubble together, that is, connect them with the remaining balloons.

3. Two 2cm bubbles are twisted into bear's small ears.

4. Then put the first bubble in the gap of the bear's face to form the bear's nose.

5. Fold the remaining balloons into 2 cm, 10 cm, 10cm bubbles, and 10cm bubbles in half to twist out the bear's hand.

6. Twist out bubbles of 5 cm, 10 cm and 10cm from the remaining balloons, fold the bubbles of 10cm in half to make bear legs, and then draw eyes with strokes, and a bear-shaped balloon is completed.