2. LED with resistor and wire (high brightness above 5000 MCD), resistor and wire;
Generally, LEDs are red, yellow, blue, green, purple, white and colorful. Generally speaking, green has the best brightness effect, followed by white, followed by blue, yellow, red and color. Method 1: directly put the lamp into the oven, set the temperature at about 120 degrees, then make sure that the oven is not preheated, put it in and heat it for 5- 10 minutes. After 5 minutes, keep looking, break it off by hand, if it is firm, keep heating for about 10- 15 minutes at most (depending on the power of the oven, but it will not exceed 20 minutes), and it can be easily opened by hand. The strength is probably like opening a strong pencil box. If it takes too long, it's probably plastic paste.
Method 2: Use a heating gun, which is not so terrible, but fast, that is, slowly walk away from the place where the gun is aimed at the sealant to ensure that the glue melts and the lampshade can be opened.
Method 3: Use a hair dryer. Suitable for people who don't have the above two tools, insert a screwdriver into the glue outlet and blow it with a hair dryer. When the temperature is enough, the glue melts, then insert it with a screwdriver, and then continue to blow it with a hair dryer, just blowing while walking, but at a slower speed.
The principle of opening the lampshade is to melt the glue, and then you can do it, so as long as you can melt the glue, you can fix the angel eye on the lamp holder with high-temperature transparent glue, and you must be resistant to high-temperature glue, because some headlights used by Taoyou have high power, and the temperature inside the lamp will be very high after a few hours of lighting. If it is ordinary glue, the glue will melt, which will cause angel eyes to fall off and cause a lot of unnecessary trouble.
After fixing, connect the angel eyeliner directly to the width indicator. Light up after installation and try the effect. Method 1: Use a heating gun to slowly walk away from the glue on both sides of the lampshade, which will melt again. At this time, just cover it and apply a layer of sealant for double protection. I usually use transparent heat-resistant silica gel, which is waterproof and sun-proof. There are many kinds of glues. If you are not sure, ask someone in the garage.
Method 2: put the lamp in the oven (suitable for riders without heating guns), but the sealing effect is the same. Set the time for 2-3 minutes, and then keep the lid open to check the glue. When it becomes semi-liquid, you can take it out and put it on, and add a layer of sealant.
The third method is to remove all the glue from the lampshade. It's best to remove the lampshade for the first time, because it's best to wait until the glue is soft. Just walk along the groove coated with glue twice with a screwdriver. Then, when sealing, just put sealant on the original groove and repackage it. Next, we need to check the working state of angel eyes. If there is no problem, load the car and connect it. If there is any problem, re-check it according to the steps of removing the lampshade above. According to the calculation method given above, the steps of connecting wires should be correct.