Led lamp is one of the common lamp products, which not only provides consumers with a variety of sizes and design styles, but also has a variety of types, including the led marquee mentioned below. Led Marquee can be purchased off-the-shelf, operated according to certain installation steps, or prepared by yourself. Then Bian Xiao will give you an analysis from these two aspects to help interested friends operate.

First, how to install the led marquee?

1, aluminum trough rail installation: first fix the bottom shell, then clip the point light source into the aluminum trough with pre-punched holes, and then directly fasten it on the bottom shell. It doesn't look at any lines, and it is beautiful and generous. This is widely used. The aluminum trough can be the same color as the wall, or it can be called led invisible light. There are no light spots during the day, but lights are everywhere at night. Installed on the roof, it can resist typhoon.

2. Installation of the buckle line: buckle the line, and then buckle the light source; Suitable for glass curtain wall or suspension installation.

3. Direct installation with screws: it can also be fixed with glass glue. In order to reduce the cost, the disadvantage of this installation method is that the power cord and the point light source connection line are exposed.

4. Perforation installation of the whole board: iron plate, aluminum plate and stainless steel plate are perforated, and then the point light source passes through the back and is connected to the wire for installation. This installation method is also common.

Second, how to make led marquee?

Steps of making Led marquee

First, we take out the red colored paper, with scissors beside it, and then cut it into squares and circles. The size of the square material is 36* 14 cm, and the diameter of the circle should be 12 cm. Square colored paper is generally used to make cylinders, and circular colored paper is used to make the top cover, which is the wind wheel. When we cut the colored paper, we roll it into a cylinder, cut out the shape of a small tooth at one end, glue it with water and bend it, so that the top cover can be glued together with it, thus forming the main shape of the marquee, and we can clearly see the general shape of the marquee.

Although there are many led racing lights on the market, most of them can guarantee excellent quality and cost performance, but it does not mean that consumers can guarantee satisfactory use effect after purchasing, because we still need to refer to the appropriate steps and methods for installation, such as the three installation methods mentioned above. In addition, friends who are interested in hands-on practice can also prepare their own materials to make led tickers, which not only saves costs, but also exercises their own abilities.