This method only applies to stickers that haven't been stuck for too long. Apply it with a hot towel before erasing, and then slowly tear it off after the sticker is soaked.
Step 2 remove with soapy water
Why is this happening? In fact, the principle is that soapy water can dissolve the glue and destroy the combination of the sticker and the glass surface. Then how to operate? The method is very simple. Just soak the glass object with the sticker in hot soapy water for 10-30 minutes, and then gently and slowly tear it off with your fingers.
Step 3 remove with alcohol
Operating steps: first, use paper towels, cotton balls or towels to dip some alcohol, and then apply it to the glass. It is recommended to wipe with a towel because it can protect the glass.
4. Remove with essential balm.
Operation steps: Apply a high concentration of wind oil essence on the adhesive, and wipe it back and forth with a dry cloth after penetration.
Step 5 remove with vinegar
Operating steps: First, apply enough vinegar on the sticker. After the sticker is soaked by paper, gently scrape it off with a small card. If the sticker is thick, you can add more vinegar to extend the soaking time.
Step 6 remove with hand cream
Operating steps: evenly spread the hand cream on the sticker, and then gently scrape it off with a small card.
Step 7 blow it off with a hair dryer
Operating steps: first turn on the hair dryer to a low temperature, and then blow the sticker at a distance of about 20cm. The principle is to soften the glue with a hair dryer. In the process of blowing, there must be a small card or ruler to gently scrape the sticker.
8. Remove with baking soda
Operation steps: firstly, mix baking soda powder and edible oil in equal amount, and then mix baking soda powder and edible oil into paste, which can be conveniently applied to the surface of an object and gently wiped.
9. Remove with WD-40 multifunctional lubricant.
WD-40 is a powerful solvent that can dissolve glue and a very strong chemical reagent. You can spray a layer of WD-40 evenly on the surface of the sticker. In order not to spray on the glass, you can spray some WD-40 on a clean cloth first, and then wipe it on the sticker. You need to wear gloves to protect your hands in the process. Don't let skin, fabric or even glass touch it!