Connecting the lamp wire is an essential step when installing lamps and lanterns, and it is the most important link to use electricity safely. Danger may occur if the operation is improper, so be careful when connecting the light wire. This paper will introduce several ways to connect the lamp wires correctly.

1. Preparation before connecting the light wire

Necessary tools, including lamp caps, screwdrivers, scissors, screwdrivers, power cords, power plugs, terminals, etc., should be prepared before installation of lamps, so as not to be nervous during installation.

2. Disconnect the wire

Before disconnecting the wire, make sure that the power supply has been disconnected to avoid danger. When disassembling, separate the wires to avoid short circuit when touching other wires.

3. Installation of terminal block

Terminal is an important part of lamp wiring, which can connect the power cord with the lamp holder to ensure the safe use of lamps. The steps of installing the terminal are to firmly insert the power cord into the terminal, then firmly insert the lead of the lamp holder into the other end, and finally cover the terminal.

4. Installation of power plug

The power plug is an important part to connect the power cord and the power interface, and it is also the key to the wiring of lamps. The steps of installing the power plug are: first insert the power cord into the power plug, then insert the power plug into the power interface, and finally cover the power interface.

Install lamp holder

Finally, install the lamp holder. When installing the lamp cap, it is necessary to install the lamp cap on the lamp with a screwdriver, then firmly insert the lead of the lamp cap into the terminal, and finally install the lamp cap.

These are the steps to connect the lamp wires correctly. Every step is very important from preparation to lamp holder installation. We should operate carefully to ensure the safe use of the lamp.