Current location - Plastic Surgery and Aesthetics Network - Wedding supplies - The first step of diy fish tank, how to put 5 pieces of glass?
The first step of diy fish tank, how to put 5 pieces of glass?
I usually: the first step is to put the bottom glass flat on a table or shelf smaller than the bottom plate (convenient for later operation).

On the edge of the bottom plate, draw a glass glue line evenly with glass glue (the width should be the thickness of glass).

Step 2, vertically press the glass with long sides on the bottom glass, so that the outer edge and inner edge of the bottom glass are flush, so that people can hold it or lean against heavy objects inside and outside, keep the vertical bottom outside, and stick the bottom and long side plates together with transparent tape.

Step 3: Glue both sides of the glass vertical bottom plate of the short board with glass glue according to the sample.

Bonding with the long board in the way of bonding with the bottom board and bonding with the bottom board; Fix the short board and the bottom board at a 90-degree angle with transparent glue, and fix the other short board according to the sample and stick it well.

Step 4, align the outer edge of the last long plate (the fifth glass plate) with the outer edges of the two short plates and the bottom plate, and stick them on three sides with transparent tape.

Step 5: Apply the glass glue evenly to the included angle seam of all two plates inside the cylinder, put on a finger sleeve, and press the glue into the gap between the two glass plates with your fingers, so as not to leave any gaps and bubbles inside, otherwise it will leak.

Step 6: Press the glue squeezed from the outer seam of the glass box tightly with your fingers, and make up the glass glue if there is a crack.

You're finished. Leave it for more than one day. After the glass glue dries, put a small amount of water to test the leakage. Try more gradually. Don't try too much, it will swell up.