Materials required:

1. Dark blue beaded 20g 2mm (diameter)

2. White beads 20g 2mm

3. Gold beads 12g 2mm

4.5 plastic imitation pearls

5. Fine iron wire 1 0.3mm (diameter)

6. Green tape 1 roll

7. Rubber band 1

8. 1 white shoelaces

Tools required:

Needle-nosed pliers and glue

Production steps:

Take an 80cm long thin iron wire and wrap it around one end (about 6cm in circumference), as shown below. You can see that there are two "tails", one of which is relatively short, about 4cm long is enough.

Put the green beads in the long "tail", and at least two-thirds of the silk is covered with beads.

Let the petals go round and round. Place the wire in the direction shown below. First, put three green beads into short wire (short wire is actually the main vein of petals).

While pressing three beads with a long wire, wrap the long wire around the beads on the main vein (short wire) and then wrap the long wire around the main vein (short wire).

Continue to push three beads from one end of the long wire to the main vein, this time around the main vein, and then around the lower end of the main vein. In this way, the first lap is completed. When winding wires, be careful not to leave too much space between beads.

Use the same method to circle the second and third times ... until the green beads on the long wire are used up. The number of beads in each circle will affect the shape of petals.

Continue to thread white beads into the long line, at least more than the green beads in the outermost circle of petals. Then it is wound on the main vein in the same way to form the outer contour of the petal. The remaining iron wire is twisted together at the lower end of the petals to make a flower stalk.

Make a few more petals in the same step and screw them together.

You can also cut off a piece of iron wire as shown below, put on pearls, twist out the trunk, and tie them together in petals.

Wrap the flower pole with green tape. Tie several beads together with a rubber band, wrap the flower stems with a white ribbon, and finally stick them with glue.