Construction technology of three-dimensional irregular soft membrane ceiling;
Step one:
1. According to the design requirements of the drawings, a circle of 4X4Cm supporting keel (wood square or square steel pipe) is fixed around the horizontal position where the flexible membrane ceiling needs to be installed.
Note: in some places, when the area is relatively large, it is required to install in blocks to achieve good results. This requires adding a wooden square in the middle. This is actually handled according to the actual situation.
2.？ When all the required battens are fixed, the aluminum alloy keel of the flexible membrane ceiling is fixedly installed on the bottom surface of the supporting keel.
Step two:
1. When all aluminum alloy keels with flexible membrane ceilings are fixed, install the flexible membrane again. First, open the soft film, fully and evenly heat it with a special heating air gun, then insert the soft film into the aluminum alloy keel with a special inserting knife, and finally completely trim the redundant soft film.
2. Installation is complete.
Detailed rules for construction technology of flexible membrane ceiling:
1. Go to the construction site first to see if it is possible to install the keel: that is, to see whether the wall site is completed, whether the woodworking part is qualified, and the plastering part needs to be completed first. Pay special attention to the woodworking part, and do it according to our requirements. The opening sizes of lamps and tuyeres should be processed in advance.
2. Site conditions allow Licensor to enter the site for construction. First of all, carpenters should do a good job of fixing aluminum alloy keel according to the design requirements of drawings. Note that the right angle must be flat and smooth, and the joint should be flat and dense.
3. Pay attention to the light frame, tuyere and smooth tube plate to be flush with the surrounding keel, and be firm and stable without swinging.
4. Smoke, ceiling lamp, position first and then make a wooden underframe. The bottom of the wooden underframe should be polished and smooth, and pay attention to the horizontal height. If it is too low, it is easy to highlight the trace of the chassis.
5. Before installing smallpox, carefully check whether the keel joint is firm and smooth, spray head should be glued with white tape, and the tuyere should be handled well. When installing smallpox, it should be fixed from the middle to both sides, and at the same time, pay attention to the dimensions of both sides, pay attention to the straight weld, and finally make an angle position, and pay attention to flatness. Trim and remove excess smallpox when the surroundings are ready. Achieve a perfect edge-closing effect.
6. Lamp hole: mark the position of the lamp hole, carefully and accurately stick the PVC lamp ring on the bottom of the soft film, and remove the excess smallpox after it is firm.
7. Air opening and smooth pipe nozzle: Find the position of smooth pipe nozzle at the air opening, install soft film on the aluminum alloy keel as it is, and pay attention to the straight angle. When finished, remove excess smallpox.
8. Finally, clean the surface of soft film smallpox with a clean towel. Membrane smallpox is very clean.
The above is the process of flexible ceiling construction technology and the matters needing attention in the construction process. Flexible ceiling is a kind of soft membrane, which can change its shape at will. This is very creative. Flexible ceiling has many good functions, such as saving energy and preventing bacteria. Most importantly, the flexible ceiling has many beautiful colors for us to choose from. What needs to be added is that smallpox is safer and more environmentally friendly, and it is another choice for us. You can compare flexible smallpox with traditional smallpox, and then decide which smallpox is better.