When decorating the living room, bathroom, kitchen and other areas, ceilings are generally needed, but there are generally many kinds of ceiling materials on the market, and the installation scheme and decoration effect of each ceiling material will be different. So how to use pvc board ceiling? Let's study with Bian Xiao. \r\nHow to suspend the ceiling with pvc board \r\n 1 If you want to use pvc ceiling, you must first play lines on the surrounding walls according to the designed ceiling height, and the position must be accurate when playing lines. The allowable deviation between grades is 5 mm. Secondly, the side keel should be fixed on the surrounding wall according to the played line. Edge keel is the sealing of ceiling edge, so the specification of edge keel is generally 25mm× 25mm, and the color of edge keel is generally the same as that of pvc board. When fixing the side keel, the side keel is generally fixed on the wall column with cement nails. \r\n3. Next, the keel position line should be determined clearly. Because pvc panels are generally shaped decorative panels, it is generally impossible to cut them into blocks. In order to ensure that the decorative surface of ceiling can form a whole and ensure the reliability of ceiling installation, it is generally necessary to install pvc board and ceiling area to arrange the structural size of ceiling keel. \r\n4。 When arranging the decorative surface of pvc board, the combination of pvc board should be complete, the surrounding edges should be symmetrical and even, and the arranged keel position line should be drawn on the edge of the height line played in advance. \r\n5。 When the spacing of lifting points is set between the main keels, the middle part should be kept bulging, and the bulging height should generally not be lower than 1/200 of the room surface span. \r\n6。 When installing the main keel, the installation position and height of the keel must be corrected in time. To control the smoothness of the dragon skeleton, you can first pull out the vertical and horizontal elevation control lines, and start from one end, while installing, while adjusting the hanging height of the boom. \r\n7。 After leveling the main decorative surface of the main keel, it is necessary to properly adjust the single keel with bending and warping until the flatness meets the relevant requirements. \r\n8。 Derrick should be straight and have enough bearing capacity. When the boom needs to be extended, the lap joint must be welded firmly and the weld seam must be uniform and full. In addition, anti-rust treatment should be carried out. The distance between the boom and the end of the main keel should not exceed 300 mm Once it exceeds, the boom should be added to prevent the main keel from falling, and the secondary keel should be installed close to the main keel. \r\n9。 Next, the installation position and levelness of the main keel and the secondary keel need to be calibrated comprehensively. The installation of connectors should be staggered. Check whether the installed ceiling frame is installed firmly and reliably. Only after everything meets the relevant installation specifications can the next step of construction be continued. \r\n 10。 When installing PVC board, the secondary keel must be straightened. PVC board should be kept flat and free from warping. The horizontal error between ceiling planes should usually not exceed 5 mm. \ r \ The above is a detailed introduction about how to suspend the ceiling with pvc board, hoping to help friends in need. When using pvc board for ceiling, each pvc board must be fixed in the corresponding position, so as to ensure that the installation conforms to the construction specifications, so as to ensure that the quality of ceiling is no problem.
Calculate how much it will cost to decorate your home.