1. crystal chandelier installation-tool materials

(1) In order to achieve better installation effect, there should be sufficient lighting after installation, and the required tool materials should be determined in advance, so that the crystal ceiling can achieve the best decorative lighting effect in the process of installing crystal chandeliers.

(2) In order to be suitable for adequate lighting, tools, such as safety ladders, screwdrivers, screws, pliers, rulers, hammers and electric hammers, need to be prepared before public service. These may be used in the process of installing crystal chandeliers, such as adhesives, plastics, glass plates and so on.

2. Crystal chandelier installation-test voltage

(1) To ensure safe operation, the power supply should be turned off first, and the live wire, ground wire and zero wire of the power supply should be separated. The ground wire is the main loop in the room, and the live wire is the connecting wire in the switch. Before installing the crystal chandelier, the voltage should be tested to clearly control the brightness of the lamp.

(2) Each set of lamps and lanterns must be connected with ground wire and live wire for the next operation, mainly to reduce the hidden danger index and protect the safety of users.

3. Crystal chandelier installation-fixed ceiling

(1) Before fixing the ceiling, turn off the power and fix the crystal chandelier base on the ceiling, but avoid other embedded lines on the ceiling to avoid damaging other power lines.

(2) Fix the crystal chain on the ceiling where it needs to be installed. The chain also needs to be reserved for a certain length so as to adjust the lighting angle in the future.

4. Crystal chandelier installation-connection circuit

(1) You can start to connect the power cord of the crystal ceiling. If you don't have professional operating experience and electrician knowledge, try not to install it yourself. First, use a wire stripper to peel off the insulation glue outside the wire, and then thread the wire into the central hole of the crystal chandelier base. Then, wrap this wire and the wire between the two sides of the chandelier with insulating tape, and take insulation measures to avoid short circuit.

(2) Re-insert new lamps and lanterns, and install ground wire and live wire respectively. Don't put it wrong.

5. Crystal chandelier installation-install lamps and lanterns

(1) You can start installing the lamps. When the power cord is connected, the baseline is worn and the link is fixed, read the instructions first and follow the above instructions step by step.

(2) The installation of crystal chandeliers is more particular. The length of the hook, the height of the chandelier and the installation position of the lamps have standard specifications. Be sure to pay attention when installing.