Someone on the internet had a quarrel about whether the arched door looked good or not.

A: "The arched door is beautiful, high and atmospheric."

B: "It doesn't look good. Arch doors and doorways of the same width look stingy. "

C: "With all due respect, the arched door is like a cave, suitable for cavemen."

To say that new internet celebrities can rank first, the arched door must have a name. Without it, it is beautiful and practical. However, as long as you pay a little attention, you will find a spicy eye phenomenon:

The arched door is good, but don't pretend ~

1

Large "rollover" scene with arched doors

Who says arched doors must be arched? There are all kinds of shapes on the internet. In fact, the reasons for these rollover cases are nothing more than:

(1) The design renderings are not well done, which leads to the failure of the master worker to install them normally.

(2) The design renderings are correct, but the master's technology is not up to standard.

In either case, the consequence of rollover is to delay the construction progress, waste materials and delay the construction period.

2

Arch decoration dry goods

The arched door must be reworked when it is turned over. Don't make a big mistake Learn this dry goods collection!

Step 1: The designer designs the effect diagram of the arched door according to the space size.

This may be a problem in many people's rollover cases. Don't think it's just an arch? Where did you get so much design expertise? Actually, there is.

The arc radius of the arch must be accurate in order to coordinate the proportion. Otherwise, it will look very petty.

Step 2: Start the construction.

A. Determine the position, height and width of the arched door according to the design drawings.

B build a bottom frame with wooden keel and fix it on the wall.

C determine the radian and size of the arched door, cut out two arches with gypsum board and fix them on both sides of the wall.

D. Measure the width between the two arches, cut out n small wooden strips with equal width and fix them from the inside with a spacing of about 5cm.

E. cut the gypsum board into the same width as the slats in the previous step. Don't cut it completely, keep the wooden strips connected. Then use an air gun to fix it on the radian of the arched door, and use dense nails to ensure it is firm enough.

F. Brush a layer of putty, and then brush it when it is dry.

G. closing has been completed.

If you just make a simple arched door, the technical requirements are not very high. However, if you want to make the ending more beautiful, you need very strong technology.

three

Precautions for arched doors

A. It is normal and beautiful to make a tall arched door with the aspect ratio of 1:2.5.

B. If there are beams at the original height, lower the height. It is not recommended to make arched doors, which are too short and unsightly.

C arched doors are not recommended when the corridor width is less than 80cm. It is too narrow and crowded.

D the thickness of the arched door should not be too thin, too stingy, and the bearing capacity is not good. Usually the thickness of two bricks.