1. To prevent dust and impurities from affecting the film pasting effect, the car body glass should be cleaned before film pasting.
2. The parts that may be damaged when sticking the car film should be covered in advance to prevent scratching the car paint, interior and other parts; Parts that may affect the construction also need to be removed in advance.
3. After the whole body is processed, the car film will be cut, and the car film will be cut preliminarily according to the size of the glass.
4. Paste the roughly cut car film on the car glass, and then bake the film according to the width of the car glass in the front and rear gears, so that the width of the car film is close to the glass, so that the pasted car film will be flat and without water marks.
After baking, the film is easy to stick to the glass. At this time, it will be further modified, that is, the corresponding shape will be finely cut according to the shape of the glass.
6. The window film is stuck inside, and the key step is to film it. The requirement of the upper mold is to clean the inside of the glass quickly and accurately and push the water out as soon as possible.
7. After all the work is completed, one last inspection is needed. After the whole vehicle is pasted, it is necessary to check the condition of each window, especially at the corner. If bubbles are found, they should be dealt with immediately.
Reminder:
It is required that the window cannot be opened for 2-5 days after sticking the film, the defogging function cannot be used in the rear block, and the front windshield cannot be blown by air conditioner; Don't scratch the glass with something with teeth; After the construction is completed, an application for quality assurance must be filled in, so that after-sales service can be guaranteed; After 3 days, you'd better go back to the store and check it again. If there is any quality problem, it should be repaired in time.