The first is to use 10 or 1 screw; No wrench; Pencil, it is recommended to use a hand drill. Insert the circular fixing head into the drilled hole. Screw the connecting rod into the expansion plug embedded in the plate. Put the 14 universal wrench into the movable door marked on the installation drawing of the telescopic dining table, do not screw it to the end first, and then adjust the height.

There is also screwing the handle into the already punched handle hole. The handle screw of the telescopic dining table may be too long, so put a gasket between the screw and the door panel. When leaving the factory, only the hinge screw holes are pre-drilled on the movable door and door panel, and the hinge holes on the two side panels and the top panel are not pre-drilled, which makes it easier for the buyer to install, and the error is small, which can only make the buyer lose money by screwing a few more screws.

There is also the folding dining table upside down and the top plate touches the ground. Hinge the No.2 desktop and the No.0/top plate to 1. Move the door panel, support the desktop, insert the bolt head into the hole on the surface of the desktop, draw the position on the movable door with a pencil, and fix the bolt. When installing the telescopic dining table, the floor should be covered with felt cloth or cardboard boxes to avoid scratching the dining table.

And screw fixation. When assembling the hinge, it is difficult to screw in the screws because the surface of the plate is hard. You can press the screw first, knock the screw a few times with a hammer, and leave a small hole on the board, which is easy to screw in. The installation of the telescopic dining table requires two to four sets of fixed heads and connecting rods, and two to six sets are put in the package, and two sets are reserved. Please don't say there are missing parts.