2。 Support for fixing the ball machine. Before installation, think about the orientation and angle to be monitored, choose the installation position and fix the bracket.
3. Wiring: Power line, video line and control line are distributed to the camera in turn. It is required to pass through the camera bracket about 15CM.
4. Test the power cord voltage to see if it matches the camera voltage. This part is very important, otherwise the camera will burn.
5. Install the camera, insert the camera cable into the camera bracket and fix the camera screw.
6. Wiring: Connect the power line, video line (BNC connector or crystal head) and control line respectively in a certain order. Connect the control lines of the optical transceiver/video recorder in the same wiring sequence. The video cable is connected to the video recorder.
7. Test the camera to see if there is any image, and control the camera to rotate up and down, left and right.
8, troubleshooting, no image, first look at whether the camera has electricity, and then check whether the BNC/ crystal head is in good contact.
The camera can't control the movement. Check whether the contact of the control lines is good, and then check whether the wiring sequence of the control lines is consistent.