Current location - Plastic Surgery and Aesthetics Network - Wedding planning company - Rabbit Hair Hairpin Weaving Course
Rabbit Hair Hairpin Weaving Course
Tool materials: square cotton cloth, circular woolen cloth, circular non-woven fabric, 2 tassels, 2 black duckbill clips, alcohol glue, scissors, needle and thread, and point drill pen.

Step 1: Sew a circular piece of cloth along the edge, remember to sew it more carefully, and you can close your mouth slightly when sewing, as shown below.

Step 2: first, knead a large ball of cotton with your hands, which is roughly oval, as shown in the figure below.

Step three. Then press the plug hard, and remember to close the plug, as shown in the figure below.

Step 4: After stuffing, fix the thread. At this time, you can rub it a little to make the rabbit's body look more round, as shown below.

Step 5, then fold the square cotton cloth in half twice, and cut it down to the sharp folding cloth from the place where the tweezers are clamped, as shown in the figure below.

Step six. Then apply alcohol glue to the folded cotton cloth and tidy it up a little, and the lovely ears will be ready, as shown below.

Step 7: Place a little bit of alcohol glue on the prepared rabbit, and then point the red rabbit eyes with a drill pen, as shown below.

Step 8: Apply a little more alcohol glue to the ear just now and stick it on the ear. The tip of the ear should be in line with the eyes, and pay attention to symmetry, as shown below.

Step 9: The tail and eyes are knitted in the same way, as shown in the figure below.

Step 10: Next, coat the two non-woven discs with alcohol glue, as shown in the following figure.

Step 1 1. Finally, first put tassels on the non-woven disc coated with alcohol, then paste the rabbit seal on the disc, and then paste the black duckbill hairpin. Here is a rabbit hair hairpin, as shown in the picture below.

The above is a knitting tutorial about rabbit hair clips, I hope it will help you.