Hello, after buying back the kit, draw a grid of 10* 10 on the embroidered cloth according to the grid number on the drawing (the seller can draw it now), and then embroider × or/it should be noted that 1 should be in the same position on the embroidered cloth according to the position of the symbol, the number of strands and the number of threads on the drawing, and the needles should be in the same direction. 2. Pin the thread in the cloth pattern on the back, and don't tie it. 3. When you pull the jumper, you can pass through the fabric on the back to keep the back clean, which is good for the color behind the embroidery and will not be messy. 4. The tightness of the stitches should be consistent, not too tight. Too tight will widen the pinhole, leaving a blank and affecting the appearance. 5, embroidery thread should not be too long, too long is easy to knot, wasting time. 6, wire back to clean up in time. Schematic diagram of stitch: cross stitch (X): cross stitch should correspond to each square in the drawing. (Figure 1) Cross stitch can be embroidered before and after (Figure 2). Vertical cross stitch can be embroidered as shown in Figure 3. Half cross stitch (1/2X): This stitch is only the first half of embroidered cross stitch. Embroidery is generally carried out from the bottom left to the top right. If there are special circumstances, please embroider upwards at the position of "1" as shown in Figure 4 (Figure 5), and then embroider downwards at the position of "2" in the middle of the fabric yarn. (As shown in the figure, the direction of the quarter stitch is different) Three-quarter stitch (3/4X): Three-quarter stitch consists of half stitch and quarter stitch (Figure 6) Edge wrapping (B'ST): The edge wrapping of the outline part (indicated by black or colored lines in the figure and on the color card) shall be carried out after all cross-stitch parts are completed. (Figure 7) French knot: thread the needle from the position of "1", pull the wire with the left hand, wind the needle from the outside to the inside with the right hand, and then thread it back from the position of "1". (Figure 8) Flat flap needle: thread the needle from "1" position to form a loop, then thread it back from "1" position, then thread the needle from "2" position to press the loop on the cloth surface and then thread it back from "2" position (Figure 9). It should be noted that: 65438+ 3. When you pull the jumper, you can wear the fabric on the back to keep the back clean, which is good for the color behind the embroidery and will not be messy. 4. The tightness of the stitches should be consistent, not too tight. Too tight will widen the pinhole, leaving a blank and affecting the appearance. 5, embroidery thread should not be too long, too long is easy to knot, wasting time. 6, wire back to clean up in time. 7. When embroidering the whole piece, always look at the wireless knot on the back. Embroider slowly, experience slowly, and sum up a set of your own tips, experiences and skills.