I'll start with a simple tutorial. As can be seen from the above picture, the bookmark I made is very simple and has no fancy. I prefer simple and generous. Too many modes always feel locked. Reading with your own bookmarks is also great! Preparation materials: the wood, keywords and bookmark materials of wooden bookmarks on Taobao are relatively cheap, a few hairs or 1 pieces, and many choices are made: green sandalwood, red sandalwood and golden sandalwood. . . . Personally, I prefer ebony. After buying it, the wood is still rough, and some shapes may not be very regular. At this time, the test of our kung fu is to polish it slightly with coarse sandpaper to remove the roughness of the wood surface, and then gradually increase the sandpaper from low wood to high mesh, not necessarily all sandpaper should be used. Low mesh sandpaper is used for shaping and roughening, and high mesh sandpaper is used for grinding. When the bookmark is finished, I want it to feel good. Polishing requires a lot of effort. Bookmarks are relatively small, and it doesn't take too long to change the shape of the surface with low mesh polishing. You can start with sandpaper, 400 _ 800 _1000 _1500 _ 2000 _ 3000. The specific mesh number depends on the polishing situation. When polishing with low mesh, pay attention to polishing several times and look at the shape. The main change of're' is polishing. After polishing, a wooden sign is almost finished. Step 2: Use low mesh sandpaper to shape the four corners to make them into rounded corners. Just grind the 400-mesh sandpaper twice to make the bookmark look better. Step 3: punch holes with an electric grinder. Remember to measure with a ruler, don't look with your eyes, and then point it at the center with a pencil. If you are afraid of using an electric grinder, put the bookmark in a vise and aim at punching holes.