The solution to the crooked spectacle legs is as follows:

1. Go to the optical shop for adjustment

Before adjusting the glasses in a professional optical shop, you should first remove each part of the frame. Tighten two screws before adjustment can begin, otherwise it will be impossible to adjust in place. When adjusting, you should first adjust the mirror surface, then the temples, and finally the nose pads. After the glasses are adjusted, you will want to wear them. Then look at the curvature of the temples behind your ears and the For the length, it is appropriate to lower your head and gently shake the glasses to prevent them from sliding down. Then fine-tune the length according to your overall wearing situation.

2. Repair by yourself

If you are too lazy to go to the optical shop for adjustment and the glasses frame is not in need of replacement, you can repair and fine-tune it yourself. If it is acetate glasses, the simplest way is to blow them with an electric hair dryer and then correct the shape. If the metal glasses frame is crooked, you can use nylon jaw chain pliers to adjust it. Be gentle, otherwise the glasses will be easily damaged.

When using a hair dryer to heat, move the hair dryer. If the lens has been fitted, it is recommended to run it through water first to prevent the lens from overheating. If the opening angle of the metal frame is too large, press the junction between the mirror and the frame with one hand and adjust it with the other hand. If using pliers, adjust the pliers inward to clamp less.

If the outward opening angle is too small, adjust in the opposite direction. If using pliers, adjust the pliers outward to clamp more. When wearing it loosely, hold the temple part and adjust it inward so that the temple can be retracted and hung on the ear more firmly. On the contrary, when it is tight, hold the temple part and adjust it outward to make the glasses wider and more comfortable to wear.

3. You can replace new glasses

Replace new glasses. If the glasses frame is severely deformed and the deformation angle is large, it may break during the adjustment process and require welding. If the glasses It's not expensive, just buy a new one.