1. Make sure that the beam emitted by the laser tube is incident on the center of 1 # reflector.
2. Stick double-sided tape in front of the 2 # reflector, move the light beam to the position closest to the laser tube, press the light spot (control the appropriate light intensity), and make a good mark (special note: in order to prevent laser radiation from hurting people, please test the approximate position of the light spot with a piece of cardboard first, and then adjust it).
3, gradually move the beam to the farthest position from the laser tube, press some, put a mark.
4. If the two marks are not coincident, adjust the 1 # mirror to make the centers of the two marks coincide.
5. Repeat the second to fourth steps until the centers of the two marks are completely coincident.
6. Stick double-sided tape in front of the 3 # reflector, move the trolley (laser head) to the position closest to the 2 # reflector, click on the point (control the appropriate light intensity) and mark it.
7, gradually move the laser head (car) to the farthest position from the 2 # reflector, press some (it is best to use a piece of cardboard to measure the approximate position of the light spot first to prevent injury), and make a mark on it.
8. If the two marks do not coincide, adjust the No.2 reflector to make the centers of the two marks coincide.
9. Repeat steps 6 to 8 until the centers of the two marks are completely coincident.
10. Stick the double-sided adhesive tape on the light entrance hole in front of the 3 # reflector, point it and mark it. If it is in the center, it is qualified.
1 1. If the laser does not fall in the center of the entrance hole, it falls on the upper and outer sides of the figure.
Up and down deviation: only the laser tube can go up or down.
Internal and external deviation: only the laser tube can be adjusted inward or outward.
In the figure, the laser tube must be lowered, and then it must be completely readjusted from the first step.
Second, the verticality adjustment
1. Adjust the light path at four o'clock and adjust the laser to the middle of the 3# mirror.
2.CM and TM series machines let the laser pass through the middle of the nozzle by adjusting the three copper screws on the 3# reflector.
3.YM series models put double-sided adhesive tape under the 3# reflector to let the laser pass through the middle of the nozzle.
4. If there is a slight deviation from left to right, adjust the headbox 3# to the left or right to make the optical path vertical.
5. If there is a slight deviation before and after, it is generally caused by the deviation of the 3# car head itself. Replace it and readjust the verticality of the light path.
More Baidu Ruixing Laser Contact