yes.
You need sufficient qi and blood energy of your body, and you need to go to bed early at night to replenish it. It can only be repaired after a new round of skin tissue grows its original form. Before planing the nail surface, it depends on the qi and blood energy of your body.
nail care methods:
1. Use nail clippers to trim the flat mouth and oblique mouth from the side where the nail is repaired, leaving the nail length you want. Trim slowly from one side, don't cut the whole nail at once from the middle, so the nail will break easily under excessive pressure.
2. We started to repair the model with sand strips.
3. After repairing the shape, apply a dead skin softener to the finger skin, and apply it to the semicircle where the nail meets the meat.
4. If there are many dead skins, pour a little warm water into a hand bowl and soak for about 5 minutes, so that the dead skins will soften and be easier to trim.
5. If there are any stings, you can cut them off with dead skin. Before cutting, apply a layer of softener on the nail edge skin, stay for one minute, wait for the keratin to soften, and it will be convenient and thorough to remove. If you peel the dead skin directly without softening, you will feel pain. When peeling off dead skin, first push the cutin on the nail surface to the nail edge with finger skin push, then trim it along the nail edge with dead skin scissors, and finally trim it to a perfect shape with dead skin fork.
Note: Push the dead skin gently with your finger skin. Pay special attention here. You can't push the dead skin hard, and push the irregular finger skin into a neat circle. The dead skin pushes at a 3-degree angle with the nail surface. Remember, it is best for the finger skin to fit the nail. Don't push the dead skin desperately for the sake of the nail bed length, which will only hurt the nail and easily infect bacteria.
6. After applying nutrient oil, it is nourished by the finger skin. Just click a little on the finger skin to pull it, and you don't need a lot. Then massage, massage the nutrient oil to the surrounding finger skin with the fingertips, and draw circles.
7. The polishing strip (polishing block) is on the stage. Grind the nail surface back and forth to smooth it, so that the nail polish will look good, and there will be no feeling of strips. This polishing should be done once a week at most, not too much, because the nails will become thinner and thinner.
8. Cotton swabs with many uses appear. Spray disinfectant or nail polish remover to clean the inside of nails! Be gentle. Don't hurt the nail bed.
9. Finger cores are easy to accumulate dirty things. If you dig with your nails, it will make the nail bed shorter and shorter, and it is also unsanitary. Therefore, it is the most sanitary to use cotton with cotton swabs and alcohol. Don't pull it too hard. If it is not clean at one time, you can do it several times, and the cotton swabs should be changed frequently!
1. Remove the oil slick on the nail surface, clean the nail surface with a cotton swab with alcohol, and remove the nutrient oil just now, so that the nail polish is not easy to fall off on the nail surface.
11. Apply base oil. The base oil has the function of isolation and protection, and it must not be less. Otherwise, nails will easily be hurt and yellow if they directly contact nail polish.
12. Apply colored nail polish, then polish it a little later. Apply many layers at once. Nails are hard to dry. If you apply it at home, wait for more than 1 minutes before applying the second layer. If you are in a hurry, use a nail dryer, which can dry colored nail polish quickly.
13 Finally, apply bright oil, and it's finished. When nail polish is applied, do not do anything else until it is completely dry. Don't leave ugly marks on the surface of nails. Tips for detecting whether nails are completely dry. Touch two nails face to face lightly. If they feel sticky, they are not completely dry. Pay attention to it. Some nails dry quickly on the surface, but they are not dry inside, so be especially careful.