Failure of forehead fat filling will not only affect the beauty of the face, but also delay the future forehead promotion. People who pursue beauty will never stop pursuing beauty. I believe that in the days to come, most of them will be unbearable with drooping and old-fashioned eyebrows. However, the failure of forehead fat filling, especially the middle part of forehead, hindered the future forehead wrinkle removal, lifting and improvement of eyebrow eye droop.

Why does forehead fat filling fail?

1, the technology does not pass.

Fat filling failed. Due to serious technical skills, the forehead was filled with too much fat, which led to the phenomenon of longevity. After absorption, the local filling was uneven, and the fat died after local filling, resulting in a lump. These phenomena can be repaired. In these cases, fat can be dissolved and liquefied by intramuscular fat remodeling, so that excess and necrotic fat can be excreted. After the intramuscular fat is remolded, the skin can be tightened, and the skin full of fat can be restored to elasticity without wrinkles.

2. Excessive forehead fat

Due to too much filling at one time, the dosage of fat filling depends entirely on the doctor's experience, and less filling may affect the surgical effect because fat is absorbed; And if it is filled too much, there is a risk of fat contracture. Experienced doctors and formal procedures are the key to the success of autologous fat filling. Everyone's body absorption is different, and how much fat can survive depends on the operation: liposuction is mild and does not damage fat, and the purification process does not damage fat cells.

How to repair the failure of forehead fat filling

Autologous fat is difficult to fill the forehead. Even many people's foreheads and their own fat can't be integrated at all, and even if they succeed in the end, there will be unnatural situations. Underfilling and overfilling will not happen to experienced doctors, but only to inexperienced doctors. Mainly because the patient's face was not designed properly before operation, or there were some problems during the operation. It leads to asymmetry on both sides of forehead after operation, but this situation can be repaired by subsequent surgery.