1, how to put a double eyelid sticker on the inner double eyelid?
The ideal range of double eyelids is 7mm when eyes are closed and 2mm when eyes are open. Therefore, the reason why people with inner double eyelids choose double eyelid stickers that can be shaped freely is because they have to observe their eyes first, and then put adhesive tapes on the required positions.
Pay attention to the orientation of the double eyelid patch. When trimming the double eyelid stickers, the side at the beginning of the tape should face itself, so that the trimmed shape is more natural. Note that the width should not exceed 2mm. Trim both ends as much as possible.
On the other hand, it is easier to form with adhesive tape. For eyes with serious inner double eyelids, the adhesive tape can be reversed, that is, the radian is opposite to the angle of the eyes, and the skin of the corner of the eye and the end of the eye can be propped up with the strength of the two tips attached by the double eyelids.
The eye shadow at the end of the eye should have a 30 radian. First, dip the eye shadow with a flat brush and sweep it back and forth in the eyelid area, which is wider than the double eyelid range just made, so that the double eyelid cream can be covered and the arc of the eye shadow can be drawn.
Step 1: Cut the double eyelid patch.
Observe your eyes, remember the crease position on the inner double eyelid, and then start to process the double eyelid patch; Cut the double eyelid patch with scissors first, because it takes less than this long to paste the natural invisible double eyelid patch, and only half or 1/3 is enough, and the time will be longer. Originally, one piece can only be used for 10 days, so cut it out and it looks like it can last for 20 days, and finally take it off with tweezers.
Step 2: Stick it on the eyelid fold.
Stick the double eyelids on the tweezers on the original folds of the eyelids. This step is extremely critical. Stick to the right position, not too greedy and not too low (you can't see the effect). The tape near the end of the eye should be stuck on the original crease.
The other end is stuck under the original crease;
Step 3, the hairpin is pressed out of the crease.
After sticking the double eyelid patch, press the eyelid out of the crease with a round hair clip, and then slowly open your eyes. In this step, you can blink your eyes a few more times to adapt your eyes to the new creases.
Brighten skin tone and eye shadow to cover it.
When you look down, you will see some tape marks, which should be covered with eye shadow. Bright gold is the most invisible. In fact, double eyelid stickers are not easy to color, so if you apply dark eye shadow, the surroundings will darken, and the double eyelid stickers will still be white. If you cover it with dark eye shadow, the eye shadow band will change obviously. Use skin-gold eye shadow with sequins, because it is similar to skin color and sequins are confusing, so the belt will not become so obvious.
2. How to choose the inner doubles?
Medium thickness
Avoid excessive thickness to increase eyelid burden or cause eyelid drooping; Too thin double eyelid patch may not be able to support double eyelids.
Good transparency
It is best to have a color close to skin color and sufficient transparency.
Suitable cutting radian
Suitable for your own eye curvature, in order to better cooperate with the eye curvature and stick double eyelids.
Porosity
Give the eyelid a chance to breathe, otherwise there will be a lot of grease in the eyelid, which will affect the fit of the double eyelid patch.
The following is the related content of "how to put double eyelid stickers on inner double eyelids" introduced by Anthony Bian Xiao, an online health care doctor of the old clan doctor. I hope it helps you. Thank you for your strong support!
3, the usage of double eyelid stickers
The first type: double eyelid patch
Advantages: high viscosity, good concealment and convenient operation.
Disadvantages: the shape is fixed and may not be suitable for everyone's eye type.
How to use:
First, hold up your eyelids with a plastic stick, and hold out the fold position of your double eyelids.
Then clean the eyelids, take a double eyelid patch with tweezers and stick it on the position just folded.
Open your eyes naturally, and your double eyelids will be affixed!
The second type: double eyelid adhesive tape
Advantages: flexible operation, can be cut into suitable shapes according to different eye types.
Disadvantages: strong professionalism and much practice in cutting.
How to use:
Cut off a small piece of tape and trim it to a width suitable for your eye shape. This technology needs to be mastered.
Stick it at the height of your double eyelids, open it and see if the position is satisfactory, and you can finish it!
The third type: double eyelid fiber
Advantages: natural ventilation, convenient shaping, suitable for thin eyelids.
Disadvantages: insufficient viscosity and weak endurance.
How to use:
First, take out a fiber, hold both ends and gently pull it apart. Be careful not to break the fiber.
After pulling, the pulled fiber is tightly attached to the eyelid;
After the eyes are opened and shaped, cut off the excess parts at both ends with scissors;
It's natural to close your eyes and open them! That's it!
You can choose the double eyelid paste and paste method that suits you according to your actual situation.