How to use hot melt glue gun?
1, hot melt glue gun working voltage is 1 10V-220V.
2. hot melt glue gun adopts a fashion bracket, with the nozzle facing down on a stable plane.
3. The hot melt adhesive strip is pushed to the gun bore from the glue inlet. (Use ∮7mm-∮ 1 1mm adhesive tape)
4. Turn on the power supply and preheat for 5 minutes, or until the rubber strip is completely melted.
5. Just press the trigger gently and let the molten glue flow out naturally. Excessive force may damage hot melt glue gun. After the operation, put the nozzle down and unplug the power plug.
6. Never pull out the adhesive tape from the glue inlet, because hot melt adhesive will cause serious burns or damage to hot melt glue gun.
How to use hot melt glue gun?
1, as far as possible to prevent the use of hot melt gun in wet environment, to prevent electric shock.
2. Due to the extremely high temperature in use in hot melt glue gun, it is forbidden to touch the gun nozzle and the glue melting place by hand.
Keep out of children's reach and store it in a safe place.
How to use it in hot melt glue gun?
1, hot melt glue gun before use should check whether the voltage meets the requirements and whether it protrudes from the power socket.
2. When hot melt glue gun is used for the first time, fine smoke will appear on the electric heating element, which is a normal phenomenon and will disappear after ten minutes.
3. After the power is turned on, it is not allowed to stand by for a long time (no more than 20 minutes). Unplug the power plug in time when you stop using it.
4, to prevent the use in extremely high temperature or extremely low temperature environment. Try to use it at room temperature.