Current location - Plastic Surgery and Aesthetics Network - Plastic surgery and beauty - How to flatten the deformation of stainless steel plate
How to flatten the deformation of stainless steel plate
1, extended hammer method. Spread the stainless steel plate on a flat base surface, hammer the uneven place hard to flatten the protruding part, and flatten the stainless steel plate by thinning. This method is more suitable for stainless steel plates with poor elasticity and thin thickness.

2. Cooling and cooling methods. Deformation of large elastic thick stainless steel plate. Stew with fire first, then pour a lot of cold water to cool, and forge hard to make the deformed steel plate smooth again.

3, stuffy fire pressure method. Use equipment to flatten both sides of stainless steel plate. Then burn it red. After a period of time, the whole stainless steel plate can be leveled.

The fastest way to punch holes in stainless steel plates.

1. When drilling on stainless steel, first determine the drilling direction, mark the drilling position, make a small hole to avoid deviation, and then drill with a rocker arm drill, because it is more convenient and labor-saving to drill with a rocker arm station.

2. When punching, workers need to put on gloves, then aim at the original small hole and punch clockwise, and cut while punching. To control the speed, not too fast, otherwise it is easy to damage the head. Under normal circumstances, it is enough to keep 200 revolutions per minute.

3. Water needs to be prepared when drilling, and the drill bit should be watered continuously, which is mainly beneficial to heat dissipation. When drilling, if you can't take out the drill bit, you can rotate it counterclockwise. After the drill bit is taken out, the periphery of the hole needs to be polished by a grinder to remove burrs, and finally the requirements of drilling can be met.