Therefore, in response to the curiosity of many friends, Bian Xiao will tell you about it. We can't generalize whether the repair method of dents in automobile doors is stretching or jacking. First of all, we should analyze the severity of the car dent from a practical point of view. If the door is only a small dent, and the dent is not deep on the plane, or it is acute or obtuse, even if it is pulled, it can be pulled well. Then I suggest that you directly use spray painting to recover the dent directly from the paint surface. In this case, the door panel can be removed without completely moving any parts of the car.
If the dent on the door is serious, or there is a long dent when the door is pulled out, there is also a dent on the rib line. As shown below, the car just grazed something else. It looks serious, but it's actually dirty. Just polish it before throwing it.
If this is the case, it can only be repaired by jacking method. The top repair needs to be carried out from the reverse side of the sheet metal, so for general repair, we need to remove the door inner panel, remove the inner panel, find the screws fixed on the door panel, and remove the screws. For the door panel removal, the owner is most worried about whether it will be broken or there will be abnormal noise after removal. But if the dent in the door can't be sucked out from the outside, such as the slender dent in this car, it must be pushed out from the inside to protect the original car paint. This is inevitable.
Open the fastener that fixes the door panel, take off the wire harness on the door panel, and fix the door panel with the fixing rod. Generally, it can be repaired by using the position of the empty gap on the door. In fact, there is no need to be too entangled in the removal of the door guard. Door guards are installed with screws and clips. These things are designed for maintenance. It's really easy for people who don't understand to remove the door panel. They just don't know where the screws are hidden. Hard break will of course break. But it is not difficult for people who understand, just like eating and drinking water.
Tilt repair requires the use of crowbar tools, which should be inserted into the door, and the edge of the sheet metal should be protected to avoid rubbing off the car paint. Move the tool to find the sunken position, and gently and evenly push out the sunken metal sheet until the metal sheet melts into the car paint, and the radian of the car paint is consistent, and the repair is completed.
If there are bumps on the above items, use a rubber hammer and a special wooden pen to knock them back and forth until the dent is mixed with the car paint.
The dent caused by friction has been repaired perfectly. See if you have a deeper understanding of the repair method of the dent in the car door. Some dents can be repaired without moving any parts of the car, but some can only be repaired by removing the door panel.