Pruning method vines should be pruned in the middle of traction. The key to pruning is that they are dormant in winter, followed by traction. In the process of pruning, it is mainly to prune the flower branches, save the bud points, and cut off the top part of the new long branches.

Old branches also need pruning, usually cutting off old branches without regeneration. If it is a vine that has been raised for more than 3 years, it is necessary to cut off all the old branches that cannot bloom, so that plants can grow and develop new branches, which is not easy to appear concentrated.

In fact, vines grow upright. Without traction, it is impossible to produce a certain bending tilt. Therefore, it is generally necessary to carry out horizontal traction, pull the branches into a straight line and tie them up.

First of all, when pulling, we should prepare supports, mainly support frames of various shapes. Only with the support point, rattan roses will highlight various styling designs. However, fences and the like can be directly applied. If you drag it to the wall of a building, you must have a support point. You can use steel nails or iron wires.

Secondly, it is necessary to plan the direction of branches as a whole. In the case of pruning, it can be clear how many branches there are below and the development direction of the branches. In the case of traction, it is necessary to traction according to the method of long branches above and short branches below.

In the case of traction, it is necessary to observe the traction of rattan roses anytime and anywhere to change it, and sometimes it may be adjusted once or twice. After traction, vines will basically grow and develop according to this trend. After that, only some pruning operations are needed.

Angela, 1984 was born in Germany, and belongs to the climbing rose vine, with branches about 3 meters long and good resistance to black spots and white powder. Angela can bloom continuously for a long time. The ground of western countries, 1969, was born in Germany. It is a climbing vine rose with branches about 3 meters long and good resistance to black spots and white powder.

In western countries, there is grass all year round, and more flowers are spent in spring and autumn. Teoxcart, bred by Linde of the Netherlands in 193 1, is a budding species and belongs to climbing rose of lianas. Its height can reach 6 meters, and its deployment can reach 5 meters. It has good resistance to black spots and white powder and can continue to bloom.