1. Disassembly: it is difficult to use brute force during disassembly, and it is easy to damage the claws of the fixing card. I suggest you use a hair dryer or a hot air gun. I use a hot air gun, the temperature is about 350 degrees, the air volume is 4-5, and all claws are heated evenly; During the heating process, feel whether the claw becomes soft by hand, and then insert the crew cut screwdriver into the claw. It is recommended to use crew cut screwdriver more often, and finally pry it in gently, which is easy to remove.
First of all, check whether each jaw is deformed, and reshape the deformed jaws with pointed-nose pliers to ensure that the inner sides of all jaws are flat.
2. Installation: Put the proper leather bowl into the fixing card, scald the claws with boiling water, and feel whether the claws are soft with your hands. Put some butter on the inclined surface of the claw and press it again after use. It's very relaxed and noisy, and it can be installed completely.
This method saves time, effort and money (without destroying the original fixing card)
How to disassemble and clean the washing machine requires only three simple steps.
How to disassemble and clean the washing machine first turn off the power switch, and we can observe the design inside the washing machine barrel. There are several screws that need to be unscrewed. After removing the screws, you can take out the protruding blades in the washing machine barrel. At this point, we need to lift the blade before taking it off. It should be noted that the back of the wave board needs to be soaked and cleaned with 84 disinfectant to restore its original clean appearance, and often a thick layer of dirt will appear if it is not removed and washed for many years. You can clearly see the four fixing screws on the top cover of the washing machine. Unscrew them and lift the upper cover. At this time, it should be noted that the upper cover cannot be completely removed, and it can only be turned back slightly and placed against the wall. Because there are water pipes and wires connected in this place, the upper cover cannot be completely removed. After opening the upper cover, it is necessary to open the cover on the drum, unscrew the screw and lift four small buttons, so that the inner cylinder cover can be easily removed.
Then unscrew the bolt at the bottom. The best choice is to use adjustable wrench. After the bolts are removed, the inner barrel can be shaken, and the inner barrel can be easily hoisted out without waiting too long. Don't think that the inner wall of the inner barrel we usually see is clean, but it is actually very dirty, especially after the inner barrel at the bottom is removed, we can see that there are still many dirty things stuck on the dirtiest outer barrel. There is no need to disassemble the outer barrel, because the drain pipe and power cord are connected below, for fear that it will be damaged when it is taken out. You can choose to take water in a bucket and pour it in, then brush it with a brush. After brushing, you need to turn on the power supply and directly choose dehydration, so that the sewage can be discharged. Here we need to repeat the same steps many times.
Disassembly and cleaning are completed in this step. Just clean and reassemble all the parts. Just a few simple disassembly and washing steps can make your washing machine look brand-new. So act quickly! When opening the upper cover, remember not to damage the power cord. According to the expert's advice, it is best to clean the washing machine every two months, and increase the washing times in the peak season of washing machine use.