First, preliminary preparation; Relocation personnel come to the door to disassemble the machine and carry complete sets of tools and safety equipment. Exemption from inspection, quotation first, maintenance later, no maintenance and no charge, etc. , completely eradicate the worries of consumers, put an end to the screwdriver factory drifting on the edge of the industry, protect the interests of consumers, and give consumers the greatest choice.

Second, the refrigerant is recovered; Start the refrigeration first, close the small valve after the external machine is running, close the big valve after the valve is frosted, and close it immediately. Unplug the power. Tighten the safety cover to collect the refrigerant in the air-conditioning mobile machine into the outdoor unit.

Third, dismantle the indoor unit; When disassembling the indoor unit, the condensed water should be prevented from flowing into the circuit board.

4. Dismantle the outdoor unit; When disassembling the outdoor unit, pay attention to balance, avoid vibration and shaking when unloading, and finally wrap it in plastic for handling.

5. installation; Pay attention to the installation position and convection when reinstalling the air conditioner. Finally, check the leakage with detergent, observe whether there are bubbles coming out of each joint, and tighten the safety helmet of the valve after confirming that there is no leakage in the system.

Sixth, check; Finally, the air in the pipeline and the machine is removed, and the trial operation is completed.

Extended data:

Precautions for air conditioning transfer:

First, pay attention to line safety: there must be appropriate power consumption, reliable dedicated line connection and reliable grounding wire.

Second, pay attention to carefully adjust the room temperature: setting the room temperature to 19C during cooling and 2 C during heating can save more than 10%, but the human body can hardly notice the temperature difference.

Third, clean the filter regularly: dust will block the mesh of the filter and reduce the effect of heating and cooling the air. It should be cleaned once every half month. Open doors and windows as little as possible and use thick curtains with less light transmission, which can reduce indoor and outdoor heat exchange and help save electricity.

Fourth, don't block the air outlet of the outdoor unit: otherwise, it will also reduce the heating and cooling effect and waste electricity.

5. Choose an appropriate air outlet angle: cold air flow is easier to sink than air flow, while warm air flow is the opposite. Therefore, the air outlet is upward during cooling and downward during heating, and the temperature adjustment efficiency is greatly improved.

Sixth, control the state setting during startup and use: set high temperature, low temperature and high temperature when starting, so as to achieve the control purpose as soon as possible; When the temperature is suitable, change it to medium-low wind to reduce energy consumption and noise.