First of all, I saw the standing begonia look so beautiful. Many friends gave me my own begonia and wanted to know how to trim it. Many of them have been in a colonial state for a long time, and the poles have been lignified. Faced with this situation, it is a bit difficult to turn it into a standing pile, so it is not suitable for repairing them. Either cut off a branch and replant it, or don't buy a slightly shaped seedling online and start shaping and curing slowly. This process is very long and takes four to six years, so there is no hurry.
Secondly, in order to become a beautiful vertical pile, of course, we must plant the antlers and begonia first. This species is relatively shade-tolerant, water-loving and fleshy. In the process of daily maintenance, everyone can keep soft light, control it to grow too long, and try not to expose it continuously. Under strong light, the growth rate will be particularly slow, and it is very likely that the skin will burn leaves and new stems. Water, on the premise of not storing water, the appropriate temperature is 5 to 35 degrees, which can properly maintain the water content of bonsai soil. If you see that the leaves have withered, there is some danger of water shortage. Friends can water them more moderately according to their natural environment.
After you start, you can choose a suitable flowerpot according to the size of the antler begonia. The specification is preferably not less than 10 cm, which can be slightly deeper. For the soil layer, it is best to use nutrient soil with strong water permeability and high fertilizer efficiency, preferably 20% to 40% of particulate matter, and the rest is cultivated soil. If you have cow dung on hand, you can mix some in the soil, otherwise you can use ordinary compound fertilizer. The purpose is to provide sufficient nutrients for the growth of begonia, and in the subsequent maintenance, compound fertilizer should continue to be applied according to its growth and development.
Anyone who has raised this variety of flowers knows that the antlers of begonia are a very strong variety, and people with a little experience in planting flowers can raise them well. So you need to pay attention to the small details above, and don't worry about whether you will live.
Finally, during the growth of begonia cornucopia, everyone can start the general shaping work. The auxiliary software needed in this process mainly includes aluminum wire and branch support frame for potted flower modeling. The purpose is to artificially change the growth direction of branches. It is very simple to use, just coil it around the pole of the apple cornucopia. More importantly, the branch support frame plays a driving role at the bottom, and there are not many good opportunities to use it, but it is essential.
Cornus officinalis needs to be trimmed to some extent before plastic surgery. The common pruning method is to remove all the lateral buds at the bottom to expose the pole. When disassembling, you can also immediately cut it off along the periphery of the pole with a knife head. If the top is picked, the lateral buds will grow. This relative height should be solved according to your own regulations. In addition to pruning the bottom, when the begonia grows to a certain relative height, such as 15 to 20 cm, the top branches are slightly loose and often need to be pitted. In that case, on the one hand, all the columns can be denser, on the other hand, the stems can be thicker and thicker, and the appearance can be improved.
Raise more meat, folk expert. If you also like this kind of antler begonia, you can start with a few and try to maintain it. At first, you can simply follow the trend, and in the middle and late stages, you can show yourself. At present, I am still in a simple imitation link. With the improvement of the maintenance time in the middle and later period, I will gain more social experience, and I will further share it with you. Flower lovers are also welcome to comment on * * * and appreciate some modeling tips of Begonia antlers.