The 50 forklifts we use will be short of 30-50 liters of fuel when working on the same day.
Some problems, such as idle speed and the maintenance of the car itself, are also related to fuel consumption, the most important driving mode.
1 Taking loading as an example, the distance angle between forklift and truck has a certain relationship. We must use forklift to work in the shortest transportation distance. After shoveling, lift the boom when reversing, and lift the boom halfway when the car leaves. When we are about two meters away from the car, the boom has basically begun to shovel the top. When the connecting pin between the boom and the bucket is at the side of the car, we have finished tipping and reversing. This is mainly because the work experience should be advanced. It should be noted that when the road surface is uneven or the car body is eccentric, do not turn sharply with your arms raised. Find a good distance and angle, and try to reduce the front brake refueling. When reversing, the starting point is the gas door, and the car body will accumulate oil slightly when moving.
Bulk materials are stacked to save materials. You don't need to step on the accelerator to block the car, arch forward. A forklift is not a bulldozer. First, divide the two sides of the material unloaded by the dump truck into several shovels. It is estimated that the forklift can push the lifting. When lifting, first close the bucket with the contents of the bucket under the material stamp, then lift the arm against the material stamp, and the front wheel goes uphill without hard refueling. When the boom is lifted to a certain height, it begins to shovel and climb up directly by using the hydraulic power of the bucket. Then throw the materials out of the bucket when you refuel. At this time, the rear iron of the forklift is basically close to the ground. This can save material and labor.
3 leveling, this requires some skills. Generally divided into flat shovel, vertical shovel and leveling. It is best to find a flat place to lay the bucket flat and slowly lift the boom according to the trend. Don't be greedy. Step on the accelerator at medium speed, lift the boom slightly when pushing hard and lift the bucket at the same time. These two movements should not be too big. During leveling, before lifting the boom shovel, the bucket will dash, so take a little bucket by the way and adjust it down appropriately. A vertical shovel is usually used to pave things. When the pavement needs to be paved, buckle the contents of the bucket where it needs to be paved, and the shovel blade is close to the ground, so that it is convenient to see the height flatness of the shovel and refuel slowly. The slight bump of the car body will leave a ridge on the road, so the height of the boom should be adjusted in time. Scraping is generally used to smooth soft places, and there is basically a general plane. Then, according to the height to be leveled, adjust whether the bucket is horizontal or vertical, put the boom in a floating position, and level reversely. Looking for a plane, you can get it out with a boom and a little force without floating the bucket.
Maintenance is the responsibility of every driver. Only by keeping his car in the best condition can he be handy. Clean the air filter in time and change the oil every time. Automobile engine aging consumes oil and oil pump.
Let's talk about this first. I will drive tomorrow. I hope it helps you.