You cannot repair door dents by yourself. Vehicle dent repair requires certain skills and special tools. When the vehicle is ready for dent repair, it needs to be repaired by a professional repair shop, so that it can achieve a good result. The effect is to ensure the integrity of the car paint as much as possible.

It cannot be said that the repair method for car door dents is pulling or jacking. First, we need to analyze the severity of the car's dent from a practical perspective. If the car door is just a small dent, not deep on the plane, but at an acute or obtuse angle, it can be closed by pulling it. Then, it is recommended that you use the pulling method to restore the dent directly from the car paint surface. In this case, it can be completed perfectly without removing the door panel.

You can choose to purchase some tools specifically designed to repair dents, but car owners should remember that not all dents can be repaired quickly. If the paint surface is severely damaged or the dents are too sharp or even have dead ends, this method of repair is generally not recommended. Except for the above two situations, most dents can be quickly repaired with a quick retrofit. To put it simply, as long as the paint is not damaged, the dent is not in the corner of the vehicle, and the dent has no blind spots, it can be repaired by yourself. Otherwise, you will have to go to the store to find a professional to repair it.

You can buy a dent repair kit online, which is not expensive and only costs a few dozen yuan. First clean the concave part, then put the special glue into the glue gun, plug it in and preheat it for about 7 minutes. Then, choose the appropriate shim, being careful to use larger shims for larger dents. The larger the washer, the greater the traction. Then, use a glue gun to evenly coat the gasket with sol, quickly stick it into the recessed position, and press gently until the special glue is fixed before letting go.

Align the hole in the middle of the traction bridge with the fixed washer, place the nut on the washer screw and tighten it, then turn the nut until it is pulled out and the depression becomes flat. After repairing, remove the tools, spray alcohol on the remaining rubber on the car body, and clean it with a spatula. If you don't want to do it yourself, then we can leave it to an outside repair shop. They have a technique called dent repair, also known as lightweight sheet metal. However, the dent repair technology is actually similar to our own hands. Use a suction cup to suck out the dent location, then use a hook to reach into the back of the dent area, then slowly push it out, and then use a rubber mallet to deal with the bulging part.