1, choose furniture, can be divided into several steps, such as wardrobe, the first thing to observe is the door, whether the door installation is asymmetric, whether the door is parallel up and down, whether the gap in the middle is uniform when the door is closed, whether there is deformation, etc. Then look at the paint surface, look at the facing side to see if there are obvious scratches, and pinch the paint surface with your nails to see if the hardness will leave nail marks. In short, look at the paint surface of furniture not only from the front, but also from the edges and corners of the furniture, whether there are obvious disharmonious paint drops, just like buying a dress, where there are threads, it is definitely unqualified.
2. After reading the paint and the door, in the closet, smell the smell first, put your head in and smell it deeply to see if there is any pungent smell, but the smell in the furniture store samples is basically covered up by the clerk with oranges, grapefruit and spices, which depends on whether your nose works normally. The correct smell is pure wood, without irritating smell. The so-called pungent smell is actually formaldehyde! ! ! You must pay attention!
3. See if the wood in the wardrobe is used well. Some furniture has good wood outside, but miscellaneous wood inside. Look back and forth to see if the wood inside is consistent with the wood outside. The most important thing is to look at the wood grain. If the wood is different, the grain will be different. If you pinch it with your nails, elm is generally strong. If the hardness does not reach a certain strength, it is necessary to carefully consider whether it is a good material.
4. Finally, look at the hardware. Hardware is very important in a good piece of furniture. Nowadays, the doors of general wardrobes are spring hinges. After closing, you can close it and see the strength of the hinge. If the force is too small, it proves that the hinge is poor. Of course, there are also good hinges. The strength is not small, and the design is reasonable. Generally, the samples in the store are very long, so you can see if the hinge part is rusted. You should read more hinges of several furniture stores, and you will get some experience. A good hinge can tell the quality of workmanship and material at a glance. And the track of the wardrobe drawer is also very important. The quality of a piece of furniture hinges and tracks is decisive!
Finally, although it is impossible for a good piece of furniture to have this kind of situation, you should check it and measure it with a ruler. Just measure the vertical and horizontal parts of the furniture with a ruler to see if it is symmetrical!
Sometimes going to the furniture city or online shop will tell you the baking process, imported paint, what materials to use and so on. In fact, there is no real baking paint technology for solid wood furniture, at least not in China.
Generally speaking, elm furniture is still very good, which is provided by Chengyitong Furniture Mall.
Question 2: Is the old elm furniture good? Advantages and disadvantages of old elm furniture elm furniture: Advantages of elm furniture: elm wood is tough, with high mechanical strength and strong corrosion resistance; Moderate hardness and strength, suitable for carving, and can be adapted to general relief carving. Advantages of elm furniture: the sapwood of elm is clearly distinguished, the sapwood is dark yellow, and the heartwood is dark purple-gray. There are three advantages of elm furniture: the texture of elm is clear, the plane is smooth, the chord pattern is beautiful, and there is a pattern similar to "chicken wing wood". Wood can be shaped, carved, polished and painted, and it can make exquisite painted crafts. Advantages 4: China's elm furniture is mainly Ming style, with simple shape, smooth lines and elegant style. Ming-style furniture is moderately decorated, moderately complicated and locally decorated. Disadvantages of elm furniture: elm is divided into old and new, easy to deform, love insects and shrink seriously. The disadvantage of the old elm is that there will be old wormholes, old cracks and old tenons in some places. Disadvantages of elm furniture: elm furniture that has been strictly dried in the drying room is not easy to crack, but elm is not easy to dry. At present, there are many elm boards in the market because of many problems in cost or equipment, and the wood drying is not in place, so the elm furniture made is easy to crack and deform. What about the old elm furniture? Since ancient times, these two kinds of wood are the best wood for folk furniture. Old elm means that the material used in furniture is old elm, which is relative to new elm. The furniture of the old elm is much more expensive than that of the new elm, so the price is also high. However, there are also many unscrupulous merchants who pass the new elm as the old elm. Note: The real old elm does not refer to how many years this elm has grown, but to the old elm beam and the old elm wooden door board removed from the old house. The time for this kind of wood to precipitate ranges from 40 to 50 years to 1000 or 200 years. Wood has always been very stable, and the furniture made will not be deformed or infected. The new elm is easy to deform and attract insects. Old elm furniture, commonly known as elm beams, is an elm beam that has been removed from an old house for many years. Because of its age, it is dry, so it is not easy to deform, and the wood of elm is very good, so as long as it can be used as wood, it has been kept. Used in old materials and new works to make all kinds of classical furniture in Ming and Qing Dynasties. There are also old elm furniture handed down from the Ming and Qing Dynasties, which are of great value. The furniture of the old elm tree is beautiful in form, and whether the shape is complex or simple depends on whether it looks good or not. The furniture materials of the old elm tree are very good. After being used as a beam for a long time, all the water in the wood runs away, so the more you use it, the more shiny it will be and never deform. Old elm furniture is exquisite in workmanship, elegant and generous, elegant in shape and has a good aesthetic intention. When buying old elm furniture, workmanship accounts for the vast majority.
Question 3: Whether elm is good at making furniture depends on how you do it. If it's a contractor, it's almost there. Generally, there is no need to do any anti-corrosion treatment, just waxing. As for the counter-offer, it depends on the quality of his wood.
Question 4: Is the elm furniture good? What are the advantages and disadvantages of elm furniture? To judge whether elm furniture is good or not, we should first start with elm. Elm is rich in Hebei, Shanxi, Shandong, Henan, Beijing, Tianjin and other places, among which Shanxi furniture is the best. Ulmus pumila furniture Because of the great difference in color between Ulmus pumila and Ulmus pumila, craftsmen often use their different colors to make furniture: with Ulmus pumila as the frame and Ulmus pumila as the core. Elm furniture has a wide variety and different styles, covering almost all types of furniture. Chairs and stools include round back chairs, official hat chairs, southern official hat chairs, rose chairs and lamp hanging chairs; Most of the beds are couches and arhat beds, and most of the desks are square tables and long tables. Cabinets are mostly large cabinets with clear top boxes. Elm furniture is both excellent in workmanship and "timid" in rural furniture. Generally follow the simple style and pay attention to practicality. Different from beech furniture in the south, elm furniture in the north pays attention to simplicity and pays little attention to details. The style of wooden furniture in north and south areas is called "south beech and north elm". The production time of elm furniture was from the early Ming Dynasty to the late Qing Dynasty, and the early elm furniture was mostly special furniture. For example, in temples, ancestral halls and other places, different regions have obvious regional characteristics. Because elm is hard and labor-consuming, it has rarely been used to make furniture since the late Qing Dynasty.
Question 5: What kind of furniture does elm make? Since ancient times, these two kinds of wood are the best wood for folk furniture.
Old elm means that the material used in furniture is old elm, which is relative to new elm.
The furniture of the old elm is much more expensive than that of the new elm, so the price is also high.
However, there are also many unscrupulous merchants who pass the new elm as the old elm.
Note: The real old elm does not refer to how many years this elm has grown, but to the old elm beam and the old elm wooden door board removed from the old house. The time for this kind of wood to precipitate ranges from 40 to 50 years to 1000 or 200 years. Wood has always been very stable, and the furniture made will not be deformed and infected. The new elm is easy to deform and attract insects.
Question 6: Is it good to make elm furniture? Elm furniture has the following characteristics:
The advantages of elm furniture are: elm is tough, with high mechanical strength and strong corrosion resistance; Moderate hardness and strength, suitable for carving, and can be adapted to general relief carving.
Advantages of elm furniture: the sapwood of elm is clearly distinguished, the sapwood is dark yellow, and the heartwood is dark purple-gray.
There are three advantages of elm furniture: the texture of elm is clear, the plane is smooth, the chord pattern is beautiful, and there is a pattern similar to "chicken wing wood". Wood can be shaped, carved, polished and painted, and it can make exquisite painted crafts.
Advantages of elm furniture: China elm furniture is mainly Ming style, with simple shape, smooth lines and elegant style. Ming-style furniture is moderately decorated, concise and decent, and the local decoration is just right.
Question 7: Which is better, elm furniture or ash furniture? Fraxinus mandshurica is widely used in custom-made furniture, such as wardrobes, cabinets and doors. The doors and cabinets in my house are made of ash wood. Pale Fraxinus mandshurica only needs to be painted thinner to look good.
Analyze advantages and disadvantages:
1. Advantages of elm furniture: the elm floor is hard, resistant to corrosion and moisture, and has good elasticity. Elm furniture is not expensive, especially suitable for mass consumption. Elm furniture has all the high-quality physical and chemical characteristics of elm, such as corrosion resistance, moisture resistance, tough texture, elasticity and strong compression resistance.
2. Disadvantages of elm furniture: elm has its shortcomings-it is not resistant to insects. The new elm furniture should also be brushed with a layer of insect repellent to prevent insects, so as to truly combine prevention and control.
1. Advantages of Fraxinus mandshurica furniture: Fraxinus mandshurica solid wood furniture has good paint performance and bonding performance. Can be placed in a dry environment, not easy to age and deform. Good elasticity and good toughness. The arts and sciences are distinct and beautiful. Carpenters prefer to use Fraxinus mandshurica for processing, which is shockproof.
2. Disadvantages of Fraxinus mandshurica furniture: Fraxinus mandshurica heartwood does not have anti-corrosion ability, white wood is more vulnerable to powder beetles and common furniture beetles, and it is easy to be eaten by insects. Fraxinus mandshurica solid wood furniture is easy to crack when placed in a humid environment.
Question 8: Which is better, oak or elm? Which is more suitable for making furniture? Elm and oak have their own characteristics and advantages. Different people have different opinions.
Advantages of elm:
1, elm is tough, with high mechanical strength and strong corrosion resistance; Moderate hardness and strength, suitable for carving, and can be adapted to general relief carving.
2. The sapwood of Ulmus pumila is clearly distinguishable, with dark yellow sapwood and dark purple-gray heartwood.
3. Ulmus pumila has clear texture, smooth plane, beautiful chords, and a pattern similar to "chicken wing wood". Wood can be shaped, carved, polished and painted, and it can make exquisite painted crafts.
4. Elm mainly depends on imports and resources, and its price is increasing year by year;
5, anti-corrosion, moisture-proof, tough texture, elasticity, strong compression resistance, etc. ;
6, elm furniture with elm unique "chicken wings", very beautiful and generous.
disadvantaged
The selection rate of elm is low, so the selection is very important. The clearer the texture and the thicker the material, the higher the price of furniture products.
Advantages of oak:
1) has obvious mountain-shaped wood grain.
2) In terms of toughness, it can be processed into various bending shapes as required.
3) In terms of texture, it is mostly used for ancient door and window plaid cloth.
4) There is a lot of infiltration in the oak pipe hole, which is used to make wine barrels.
disadvantaged
1) Because of the high moisture content of oak, it is difficult to remove moisture, and it may start to deform or shrink and crack after one and a half years.
2) Fraxinus mandshurica replaces oak widely in the market. If the customer's professional knowledge is insufficient, it will directly affect the interests of consumers, because lines are as difficult to identify.
4) Oak sapwood is soft and vulnerable to pests.
5) No bearing capacity, usually not used in buildings.
Question 9: Is elm furniture easy to make or ash furniture easy to make? Old elm furniture is good.
Question 10: Which wood is better for furniture, elm or ash? Ash genus
Wax Mu Yi is curved, easy to process and shape, and beautiful in appearance, which makes Fraxinus mandshurica one of the popular first-choice woods in furniture industry and cabinet industry. white
Almost all sapwood and heartwood of wax wood are pale pink.
Or dark cream. However, the tree lines are quite different, and the longitudinal section is striped and the transverse section is corrugated. Fraxinus mandshurica is often used to make bentwood because of its good elasticity and strong viscosity. In addition, Fraxinus mandshurica is also easy to polish.
A list of ash trees
Volcanic ash is distributed in Russia, North America and parts of Europe. Under the condition of humidity of 65438 02%, the weight of Fraxinus mandshurica wood is 600-700 kg per cubic meter. Ash likes well-drained soil and usually grows in river valleys. The height of volcanic ash can reach 120 feet (36.6 meters) and the diameter can reach 6 feet (1.8 meters). About half of the trunk is unbranched.
Woodworking use
Strong and elastic wood is usually used to make tool handles, furniture, softball bats and other sports equipment. Ash is one of the most popular economic timber in the United States.
"A knot in one's eyes" means that people are not enlightened and it is difficult to give up. From this word, we can see some properties of elm. Ulmus pumila has a wide width and excellent texture. Small deformation rate, tough wood and clear texture,
Moderate hardness and strength, suitable for carving, smooth plane, beautiful chord pattern, "chicken wing wood" pattern, can be used for furniture and decoration. Elm furniture is rough in texture and simple in style. Elm is cost-effective
Ulmus pumila is suitable for the north, which is mainly composed of hybrid grains, while it is wet and easy to crack in the south. The advantage is that it is cheap.
Fraxinus mandshurica is generally an imported material with good elasticity and beautiful mountain patterns. It is suitable for all kinds of furniture, and it is also a high material. The price is higher.
If you pay attention to cost performance, please choose elm, if you pay attention to quality, please choose ash.