When designing a kite pattern, fold the paper in half, draw only the right side of the pattern, and draw the other side with light perspective.

2, the method of bamboo cutting

Saw the bamboo to the required size, and then split it in half first. Split the other half of the sawdust and split it with the opposite side of the knife. Cut off the bamboo joints inside, and don't remove the bamboo joints for the sake of beauty, so as not to cause the bamboo to break. When splitting bamboo, if the thickness of bamboo pieces is uneven, the splitting knife should put pressure on the thick pieces.

3. Plastic surgery

Use a plane or knife to plane. Don't bend at will except fire, so as not to hurt bamboo fiber. First, align one side of two bamboo strips completely. Hold the bamboo stick tightly with your left hand and let go with your right hand. With a thin pencil, draw a horizontal line on the long bamboo pole at about 1/2. At the same time, compare the short bamboo upside down with the long bamboo. When there is a gap, aim at the mark of the long bamboo and draw the second mark on the short bamboo. Take the center point of two points on the short bamboo as the center line of the length of the short bamboo. The inside of the bamboo strip is facing down, and the small blade is placed on the center line. Weigh the bamboo strips to see if the two sides are balanced. You can also put the center of a short bamboo on the main shaft to see if it will be balanced. Gently press your hands to bend them to see if the radian is even.

4. Bone fixation

Mark the bamboo strips first and smoke them with alcohol lamp. When smoking and baking, bamboo strips should not be too close to the fire or too long. When bamboo strips are heated, it is advisable to exert a little force on both ends of bamboo strips to bend them. When the bamboo strips are too dry, they should be soaked in water for about 2 hours.

When baking wings, the end of the wings should be about 5 cm higher than the design, so that the kite cloth can be stretched elastically. According to the design point of view, paste white glue, tie it with cotton thread and cross it. Tie the wings according to the design, and the tail ends of the two wings should be about 5 cm high.

Step 5 cut

When cutting the wing surface, leave more 1 cm for sticking bamboo.

Step 6 paste noodles

Paste white glue on the skeleton. White glue is mostly coated on the external bamboo joints, and it will never be coated on the internal bamboo joints. Stick it on the cloth after painting. If the mask is made of silk, pay attention to the warp and weft when cutting.

7. Decoration and beautification

You can use strange ink to color, and if you want to lighten the color, you can add a stupid dilution. You can also use water-based poster colors.

8. Lift the wire

Lift the string on the front of the kite (the side without bamboo strips). The picture on the left is the best position to lift the string. The lifting angle can be adjusted according to the size, structure, weight and wind power of the kite. The length of the messenger wire is 1/2 of the width of the kite body.

9, messenger wire binding method

Whether lifting the thread upwards or downwards, the ends should be tied to bamboo strips to prevent slow buckle and slippage.

10, connection of flying wire and messenger wire

Pay-off of single-ring slipknot connection slowly passes through the anti-twist joint, winds the pay-off, ties a slipknot on the ring, and tightens the lock.

In order to prevent knotting, torsion resistance can be used for fishing.