Motorcycle tires are generally replaced every 3 years or 60,000 kilometers. Check the tires before each ride. If cracks or bulges are found, replace the tires immediately. Also pay attention to the tire pressure. Motorcycles Insufficient tire pressure will cause excessive tire deformation, which will not only damage the tires, but also make the handling more sluggish, reduce the cornering limit, and easily cause a crash.

Keep the tires in good condition and the treads clean: Check the treads of the front and rear tires every time after picking up the car, and remove small stones and other foreign objects embedded in the treads. If you find small iron nails or small iron pieces, take them out immediately and carefully check whether the inner tube is punctured.

It is generally not suitable to repair motorcycle tires because the hot-patched tread is higher than other parts and the vehicle will bump up and down when driving. It is best to repair the inner tube by fire repair method. When there is a lack of fire repair materials and clamps, cold repair tape can also be used. If you often pass through unclean road sections, there are often scattered iron filings and broken glass on the road. In order to prevent the inner tube from being punctured and unable to be repaired, you can bring a set of special tools with the vehicle. They are: two tire levers, a small air pump, A handful of small folding shears, a tube of patching glue, and several pieces of tire patching tape. The replacement of the inner tube mainly depends on its aging and intactness. Although the punctured inner tube has been repaired, its reliability has been greatly reduced compared with the intact inner tube that has not been punctured.

Generally, if an inner tube has been used for one year or has traveled more than 8,000 kilometers, you should consider replacing it with a new one. When replacing a new inner tube, it is best to apply a thin layer of talcum powder on its outer surface before inserting it into the outer tire. This can prevent the inner tube from aging and adhering to the outer tire.

The replacement of tires mainly depends on the wear degree of the tread pattern. Excessive tread pattern wear will reduce driving stability and easily cause sideslip.

When loading and unloading tires, it is best to have a special tire lever (plate) and do not use tools with sharp edges to prevent damage to the tires during the operation.