Unified processing type
A set of furniture generally only uses one type of handle (also uses the same type of handle with different lengths, such as non-standard handle and special-shaped aluminum bar handle).
Horizontal installation and vertical installation of the handle are unified.
Generally, the horizontal and vertical installation of handles in a set of furniture should be unified (including the shape and orientation of single-hole handles), but the handles of drawer panels, flip doors and flip doors should be installed horizontally.
Installation position of door handle
The upper cabinet door handle is installed below the door panel, and the lower cabinet door handle is installed above the door panel. The installation position of the door handle on the cabinet should be based on the principle of convenient use.
Installation position of door handle
Drawer panel, lower swing door, upper swing door and door panel with door fittings are generally installed in the width center of the door panel, and the handle for opening the door panel is generally installed on the side far from the hinge.
Installation height of drawer panel handle
The handle of the drawer panel has two installation heights, which are respectively installed at the height center of the panel or at a uniform height from the upper edge of the panel.
Distance between the hole position on the side of the handle and the edge of the plate
When pulling the handle, the distance between the side hole of the handle and the edge of the plate is generally 45 mm