Current location - Plastic Surgery and Aesthetics Network - Plastic surgery and beauty - Hello, radio lovers, I'm a novice at broadcasting. Want to know if this hand fits?
Hello, radio lovers, I'm a novice at broadcasting. Want to know if this hand fits?
The function of this hand desk is very powerful, and it is really cheap in domestic desks; It can be used not only for two-stage ultraviolet communication, but also for relay stations (that is, cross-stage ultraviolet transmission), and also for receiving signals from wireless microphones, being used as FM radios and listening to aviation frequency bands. There may be many functions that I don't understand at first.

However, with the deepening of hobbies, these functions are very practical. If economic conditions permit, it is recommended to buy this one; Because the volume adjusting potentiometer of the handheld platform is easy to be damaged, it is more appropriate to recommend TYT F8 which is cheaper and easier to operate in the learning stage.

Extended data:

The working principle of walkie-talkie is as follows:

1, transmission part:

A phase-locked loop (PLL) and a voltage-controlled oscillator (VCO) generate a transmitting RF carrier signal, which is buffered, amplified and amplified to generate rated RF power, and harmonic components are suppressed by an antenna low-pass filter, and then transmitted by an antenna.

2. Receiving part:

The receiving part mixes an amplified signal from a radio frequency with a first local oscillator signal from a PLL frequency synthesizer circuit at a first mixer, and generates a first intermediate frequency signal. The first intermediate frequency signal further eliminates the clutter signals of adjacent channels through a crystal filter.

The filtered first intermediate frequency signal enters the intermediate frequency processing chip and is mixed with the second local oscillator signal again to generate the second intermediate frequency signal. The second IF signal is filtered, amplified and frequency-discriminated by a ceramic filter to generate an audio signal.

After amplification, band-pass filtering, de-emphasis and other circuits, the audio signal enters the volume control circuit and power amplifier for amplification, driving the speaker and getting the information people need.

3, modulation signal and modulation circuit:

The human voice is converted into audio electrical signals through a microphone.

4, signaling processing:

The CTCSS/CDCSS signal generated by CPU is amplified and adjusted, and then enters the voltage controlled oscillator for modulation. A part of low-frequency signals obtained after receiving frequency discrimination are amplified, filtered and shaped by a sub-audio band-pass filter, and then enter the CPU, where they are compared with preset values, and the results control the output of the audio power amplifier and speakers. That is, if it is the same as the preset value, turn on the speaker; If not, please turn off the speakers.