Tearing nose mask:

Step 1: First, apply a warm towel to the nose to open the pores. If you are bored, you can boil hot water at about 40 degrees first, and then apply hot water to your nose by hand.

Step 2: Then dip some water with your index finger and put it on your nose. Do not use too much water. Too much water, strong adhesion and pain.

Squeeze out a proper amount of nasal mask cream, evenly spread it on the nose, and then tear it off after drying. Don't take too long. It takes a long time for the nasal patch to stick to the nose, and it will be torn off only when the adhesion is strong, which will of course be very painful.

Step 3: Finally, soak the cotton pad in shrinking water and apply it to your nose. In the process of moisturizing, the pores of the nose gradually close. At this point, the whole step of nasal care has been completed!

Sticker nasal membrane:

Step 1: Wash your face with cleansing products, and then slightly moisten your nose with clear water.

Step 2: After the hands are completely dry, take out the nasal patch from the bag, tear the transparent film, aim the center of the nasal patch at the bridge of the nose, stick the smooth surface on the nose, and exhaust air along the bridge of the nose to make the nasal patch close to the nose.

Step 3: Wait for the nasal patch to dry completely. It takes about 10- 15 minutes in summer and about 5- 10 minutes in other seasons.

Step 4: finally, slowly tear it from both sides of the nose, and then soak the toner with a cotton pad and apply it to the nose.

Wash nose mask:

Step 1: Take it out and gently rub it on your fingertips. For the purpose of dry skin, massage it at 1 for about 3 minutes.

Step 2: Rinse with warm water. If you continue to massage with the pores open, you can effectively remove the corner plug.

Step 3: After cleaning, gently remove the black head of the angle bolt with a nose stick or pressure stick.