You are generally talking about two knives, that is, the excircle and the end face of the car.

Set your T0 10 1 as the main point, that is, the outer circle of the car, and T0 102 as the auxiliary point, that is, the end face of the car.

First, call T0 10 1 to repair the outer circle of the trial run, measure the diameter, and then enter the size of X. 。

Then call the T0 102 tool to repair the end face of the trial run, and input the z value.

Then use calipers to measure the X-Z distance between the main tool tip and the auxiliary tool tip, and then set the Z-X values of the main tool tip and the auxiliary tool tip respectively. Generally, the requirements of the Z direction of the main tool tip are not strict, and the requirements of the X direction of the auxiliary tool tip are not strict.

When using, please note that T0 102 is called when turning the end face and T0 10 1 when turning the outer circle.