Thoroughly airing and watering, basking in the sun in the morning and evening, can avoid vain growth.
How to prune the branches and leaves of the longevity flower? 1, it is best to pick the heart when the new leaves begin to grow in spring, so it is easy to recover, and new branches and leaves will sprout and make them bloom more and more luxuriantly.
2. Spend every year on troubleshooting. Only about 3 cm of branches need to be left before July, and the rest can be cut off (no leaves can be left at all). When pruning, it is necessary to cooperate with changing pots and fertilizing, and the cut branches can be used. After a long life, many buds will grow, and then the plant will be kept within 10- 15 cm, and the excess can be removed.
Don't prune after the end of March and September, because the longevity flower begins to breed and is ready to bloom.
Growth habit: I like warm, slightly wet and sunny environment. It is not cold-tolerant, and the suitable growth temperature is 15~25℃. If the temperature exceeds 30℃ in summer, the growth will be hindered. The indoor temperature should not be lower than 12℃ in winter, preferably above 15~ 18℃ during the day and above 10℃ at night. Below 5℃, the leaves turn red, and the flowering period is delayed or cannot bloom normally. In winter and spring, if the room temperature exceeds 24℃, flowering will be inhibited, and if the temperature is around 15℃, flowering will continue.
Longevity flowers have too many branches and leaves, how to trim them? First, we have to overhaul the flowers every year after they fail. Only about 3 cm of branches need to be left before July, and the rest can be cut off (no leaves can be left at all).
Pay attention to cooperate with changing pots and fertilizing when pruning, and the cut branches can be cut.
After a long life, many buds will grow, and then the plant will be kept within 10- 15 cm, and the excess can be removed.
Don't prune after the end of September, because the longevity flower begins to breed and is ready to bloom.
Long-lived flowers and long leaves. Can its branches be pruned? You can remove one or two leaves near the bottom. One is to keep ventilation, and the other is to avoid getting into trouble.
* * * Too much and too long to trim? Suggestion: Hello, according to your complaint, your conditions are too long. Regarding your question, I can tell you for sure that how long your * * * is depends on your endocrine situation. You can trim it, because what you said is wet. But I suggest you don't dial it by hand, for fear of causing hair follicle inflammation. You can also shave it off.
Can I trim the branches and leaves of the white orchid now? Potted plants, too high. Can't! Summer is the flowering season of white orchids. It is suggested that dead branches, diseased branches, clustered branches and over-dense branches should be cut off after dormancy in autumn to minimize the nutrient consumption of plants.
Can the new species of safflower relay wooden ball prune the branches and leaves? No need.
Breeding method:
Grafting:
Cutting and budding are mainly used. Grafting can be carried out in February ~1October, cutting is better in spring, and bud grafting is suitable in September ~1October. Take small and medium-sized plants of Ailanthus altissima as rootstock for multi-head grafting, strengthen the management of water, fertilizer and pruning, and make them leave the nursery within 1 year.
Cutting:
It can be carried out from March to September. Choose loose loess as cutting substrate, ensure that the cutting substrate is ventilated and high in air humidity, keep warm but avoid direct sunlight, and pay attention to ventilation of cutting environment. Under warm and humid conditions, the cuttings of Acer mono formed a red healing body within 20-25 days, and after 1 month, 3-9 new roots grew, with a root thickness of 0. 1cm and a length of1~ 6 cm. The propagation coefficient of cutting method is large, but its growth potential is weak and it takes a long time to leave the nursery. The seedlings grafted by many heads grow vigorously and come out of the nursery quickly, but it takes more labor. Cutting the tender branches from May to August, using the semi-lignified branches of that year, cutting them into 7 ~ 10 cm long cuttings, and inserting human soil1/3; The matrix of the inserted bed can be perlite or mixed with 2 parts of river sand, 6 parts of loess or mountain mud. After transplanting, build a shed for shade, spray water in time to keep the soil moist, and take root in 30 ~ 40 days.
Acer truncatum var. (Latin name: Acer truncatum var. Rubrum), also known as Acer negundo, Acer negundo, Acer negundo, Acer negundo, Acer negundo, Acer negundo, Acer negundo, belongs to Hamamelidaceae, Acer negundo. Bark is dark gray or light gray-brown, much branched. The shoots are reddish brown and densely covered with stellate hairs. Leaves leathery alternate, ovoid or ovoid, 2 ~ 5 cm long, short and sharp at the top, round and oblique at the base, asymmetrical, with stellate hairs on both sides, full and dark red. There are 4 petals, with a purplish-red line length of 1 ~ 2 cm, and 3 ~ 8 flowers clustered at the end of branchlets. Capsule brown, nearly ovoid. The flowering period is from April to May, and the flowering period is longer, about 30 to 40 days, and it can bloom again on National Day. 3 ~ 8 flowers are terminal on the main stem, purplish red. The fruiting period is August. Mainly distributed in the middle and lower reaches of the Yangtze River and its south and northern India. Flowers, roots and leaves are medicinal.
How to trim the branches and leaves of Yongchun flower? Cut it short after spring flowers, apply decomposed cake fertilizer or base fertilizer once, and apply manure every half month during the growing period. Remember to apply more phosphorus and potassium fertilizer in the later growth stage to promote the branches to be stronger after pruning. Daily management is mainly to keep the soil moist without watering. When the climate is dry, it can be used to increase humidity and prevent water from accumulating in the basin after rain. In summer, when the head of the fierce mouth has high temperature, it is more beneficial to move to the semi-shade. Before and after the Spring Festival, move the flowerpot into the greenhouse or plastic shed, keep the room temperature at about 15℃, and you can see the flowers in about 15 days.
Do azaleas need pruning? It needs pruning after flowering.
After potted azaleas wither, the pots should be changed in time, and new culture soil (the ratio of peat soil to perlite is 3∶ 1) should be replaced, and the pH value should be adjusted to 4? 5~5? 5, timely cut off dense branches, residual branches, dead branches, cross branches, twigs, long branches and diseased branches. In the growing period, the unnecessary branchlets on the branches should be thinned out. When pruning, be careful not to cut the branches that need to be preserved, because many families of rhododendron leaves are born at the top of the branches. After flowering, new branches and a cluster of new leaves grow, and the old leaves fall off immediately, and then the terminal buds begin to differentiate into flower buds. Therefore, it is very important to leave strong branches, which is related to the number of flowers next year. After the new branches germinate, they can be trimmed and bundled, so that they gradually become "umbrellas", "towers" or other ornamental plant shapes.
How to prune branches and leaves after azaleas bloom? Rhododendron has a strong ability of germination and regeneration. Every 1-2 years, after the flowers wither, it is necessary to change a bigger flowerpot and put in new culture soil. Experienced florists often combine pruning and shaping when changing pots, and consciously prune a beautiful tree. When cutting sulfur, close branches, cross branches, twigs, drooping branches, creeping branches and insect branches should be cut off, which is not only for the beauty of the tree, but also for improving ventilation and light transmission conditions; Save nutrients, make the main branches strong, so as to sprout new buds as soon as possible, so as to achieve the goal of more flowers, bigger flowers and brighter colors in the coming year.
After azaleas are in full bloom, their residual flowers often last for a long time and consume a lot of nutrients. In order to prevent nutrients from being consumed in vain, residual flowers should be picked in time to supplement nutrients for the needs of new germination technology. Besides, Xia Juan, who has a shorter plant, has many branches. Every spring, many branchlets will grow on the branches of the roots. In order to concentrate nutrients on the main branches and flowers and make them grow faster and bigger, these branchlets should also be cut off in time. If there are too many flowers, remove all the branches except each branch with a length of 1. What kind of trees to prune can be decided according to your own preferences, such as umbrella, circle, semicircle, pagoda, square and so on. You can choose at will and then trim it deliberately.