Sand making machine is not a particularly precise production equipment, but a mine crusher, specifically a further processing equipment for machine-made sand and gravel raw materials. Sand making machine and sand making machine are the same mineral processing equipment, so don't be confused by the name. It is a common equipment in industrial machine-made sand production, and the strength of sand making machine is to make fine ore into sand.

As a necessary equipment for producing machine-made sand, the structural design of sand making machine is built for producing machine-made sand. It adopts a unique feeding crushing structure with different crushing cavities, and realizes the free conversion between "beating stone" and "beating stone while striking iron". The finished product has standard particle size and reasonable gradation, which has greatly played an advantage in artificial sand making and stone forming.

Matters needing attention in using sand making machine

1. Clean the periphery of the machine, especially the periphery of the belt. Don't put any sundries in order to prevent sundries from entering the belt and causing machine failure. Do not change the belt at will. If you want to change the belt, you must change the belt of the same model. Too tight or too loose may affect the granularity of the product.

2. Before the sand making machine is used, it is necessary to check the fastening condition of each fastener in detail to see if it is loose. If it is loose, it should be reinforced and tightened.

3. Before starting the sand making machine, check whether the hammer head and rotor operate normally, whether there is any collision in the cavity, whether the rotor rotation direction is consistent with the arrow, and whether the motor and sand making machine are well lubricated.

4. After the sand maker is started, it should idle for two or three minutes before starting production.

5. After the sand making machine is used for a period of time, check the internal wear regularly, such as the wear degree of the feed pipe, cone cap, upper impeller, down runner liner and circumferential guard plate. Replace it in time after wear.